L6FB50489 USER MANUAL EN User Manual Washing Machine
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION............................................................................................................6 4. ACCESSORIES........................................................................................................... 10 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com by clients in hotels, motels, bed & breakfast and other residential type environments; – areas for communal use in blocks of flats or in launderettes. Do not exceed the maximum load of 8 kg (refer to the "Programme chart" chapter). The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering.
ENGLISH • • • • • • • • • • • the drum to prevent an internal damage. Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear. Do not install or use a damaged appliance. Follow the installation instructions supplied with the appliance. Do not install or use the appliance where the temperature can be less than 0°C or where it is exposed to the weather. The floor area on which the appliance is to be installed must be flat, stable, heat resistant and clean.
www.aeg.com substances. It can damage rubber parts of the washing machine. Prewash such fabrics by hand before loading them into the washing machine. • Do not touch the glass door while a programme is in operation. The glass can get hot. 2.5 Service • To repair the appliance contact an Authorised Service Centre. • Use original spare parts only. • Disconnect the appliance from the mains electrical and water supplies. • Cut off the mains electrical cable close to the appliance and dispose of it.
ENGLISH 5. Put the front polystyrene packaging element on the floor behind the appliance. 6. Carefully put down the appliance with the rear side on it. Make sure not to damage the hoses. 7 9. Remove the power supply cable and the drain hose from the hose holders. It is possible to see water flowing from the drain hose. This is due to the testing with water of the appliance in factory. 7. Remove the polystyrene protection from the bottom. 10.
www.aeg.com A correct adjustment of the appliance level prevents the vibration, noise and the movement of the appliance when in operation. We recommend that you keep the packaging and the transit bolts for any movement of the appliance. When the machine is installed on a plinth or if a washer dryer is stacked on the washing machine, use the accessories described in chapter 'Accessories'. Read carefully the instructions supplied with the appliance and with the accessory. 3.
ENGLISH 4. Connect the water inlet hose to the cold water tap with 3/4" thread. 9 You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 1. Make a U shape with the drain hose and put it around the plastic hose guide. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short.
www.aeg.com 5. Without the plastic hose guide, to a sink spigot - Put the drain hose in the spigot and tighten it with a clamp. Refer to the illustration. The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 38 mm min. 1.5") must be larger than the external diameter of the drain hose. 4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe.
ENGLISH 4.3 Stacking kit 11 using the correct stacking kit manufactured and approved by AEG. Verify the compatible stacking kit by checking the depth of your appliances. The stacking kit can be used only with the appliances specified in the leaflet provided with the accessory. Read carefully the instructions supplied with the appliance and with the accessory. WARNING! Do not put the tumble dryer under the washing machine. The tumble dryer can be stacked on the top of the washing machine only by 5.
www.aeg.com 1 2 3 4 5 6 7 Worktop Detergent dispenser Control panel Door handle Rating plate Drain pump filter Feet for levelling the appliance 8 9 10 11 12 Drain hose Inlet hose connection Mains cable Transit bolts Hose support 6. CONTROL PANEL 6.1 Control panel description 2 1 3 Programme Zeitvorwahl Baumwolle Baumwolle Eco Pflegeleicht Feinwäsche Wolle/Seide 20 Min. - 3 kg Baumwolle 20° Daunen 95° 1400 60° 1200 40° 800 Ohne Schleudern Spülstopp 30° U./Min. Temp.
ENGLISH 13 6.2 Display A B A C D E The digital indicator can show: ). • Programme duration (e. g. • Delay time (e. g. or ). • Cycle end ( ). ). • Warning code ( B Extra rinse indicator. It lights on when this option is selected . C The tions. D Child safety lock indicator. E Door locked indicator. indicator blink during the laundry load detec- 7. DIAL AND BUTTONS 7.1 Ein /Aus Pressing this button for a few seconds allows to activate or deactivate the appliance.
www.aeg.com 7.3 Temp. When you select a washing programme, the appliance automatically proposes a default temperature. Set this option to change the default temperature. The indicator = cold water of the set temperature comes on (the appliance does not heat the water). 7.4 U./Min. When you set a programme, the appliance automatically sets the maximum spin speed allowed. Touch repeatedly this button to: Activate the Spülstopp option • Set this option to prevent the laundry creases.
ENGLISH Touch this button once to decrease the duration. In case of smaller load, touch this button twice to set an extra quick programme. 15 7.8 Start/Pause Touch the Start/Pause button to start, pause the appliance or interrupt a running programme. The indicator of the option and the indicator of the set value are on. 8. PROGRAMMES 8.
www.aeg.com Programme Programme description Synthetic items requiring a gentle wash. Normal and light Leichtbügeln soil.3) Pumpen/Schleudern All fabrics, except woollens and delicate fabrics. To spin the laundry and to drain the water in the drum. 1) During this cycle the drum rotates slowly to ensure a gentle wash. It can seem that the drum doesn't rotate or doesn't rotate properly, but this is normal for this programme.
ENGLISH Programme Default tempera- Reference spin ture speed Temperature Spin speed range range Maximum load 1400 rpm 1400 rpm - 800 rpm Pumpen/Schleudern1) 17 8 kg 1) Set the spin speed. Make sure it is suitable for the type of fabric being washed. If you set the No Spin option then only the drain phase is available. Feinwäsche Wolle/Seide 20 Min.
www.aeg.com 8.2 Woolmark Apparel Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine. Follow the garment care label for drying and other laundry instructions. M1511 The Woolmark symbol is a Certification mark in many countries. 9. SETTINGS 9.
ENGLISH 19 11. DAILY USE WARNING! Refer to Safety chapters. 11.3 Filling the detergent and additives 11.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the button for a few seconds to activate the appliance. A short tune sounds (if activated). The programme dial is automatically set on Cotton programme . 11.2 Loading the laundry 1. Open the appliance door. 2. Shake the items before you put them in the appliance. 3.
www.aeg.com 1 2 3. To use powder detergent, turn the flap up. With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. 4. To use liquid detergent, turn the flap down.
ENGLISH 11.6 Starting a programme with the delay start 11.8 The ProSense load detection Touch the Start/Pause button. The appliance starts the countdown of the delay start. When the countdown is completed, the programme starts. After touching the Start/Pause button the ProSense technology starts the laundry load detection: The PROSENSE adapts starts at the end of the countdown. Cancelling the delay start after the countdown has started To cancel the delay start: 1.
www.aeg.com If the ProSense phase is already carried out and the water filling is already started, the new programme starts without repeating the ProSense phase. The water and the detergent are not drained out in order to avoid waste. 11.11 Opening the door Adding garments While a programme or the delay start operates, the appliance door is locked. If the temperature and level of the water in the drum are too high and/or the drum still rotates you cannot open the door. 1. Touch the button Start/Pause.
ENGLISH • After 5 minutes from the end of the washing programme Press the Ein /Aus button to activate the appliance again. The display shows the end of the last set programme. Turn the programme dial to set a new cycle. 23 If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drain the water. 12. HINTS AND TIPS WARNING! Refer to Safety chapters. 12.
www.aeg.com 12.4 Ecological hints 12.5 Water hardness • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains or use a stain remover, set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness".
ENGLISH 25 13.5 Cleaning the drum Regularly examine the drum to prevent rust particles. For a complete cleaning: 1. Clean the drum with special products for stainless steel. Always follow the instructions that you find on the packaging of the product. 2. Run a short cotton programme at high temperature or use if is available programme Maschinenreinigung. Add a small quantity of powder detergent into empty drum, in order to rinse out any left residues. 3.
www.aeg.com Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code without removing. Let the water flow out. . WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to clean the pump: 1. Open the pump cover. 2 1 2.
ENGLISH 27 10. Clean the filter under the water tap. 1 2 3 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 2. Remove the inlet hose from the appliance by loosening the ring nut. 2 1 3. Clean the valve filter on the back of the appliance with a toothbrush. 12. Close the pump cover. 2 1 13.
www.aeg.com values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 45° 20° 13.9 Emergency drain 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Put the two ends of the inlet hose in a container and let the water flow out of the hose. 4. Empty the drain pump. Refer to the emergency drain procedure. 5. When the drain pump is empty, install the inlet hose again.
ENGLISH The programme was not finished properly or the appliance stopped too early. If the alarm code appears again, contact the Authorised Service Centre. • - The anti-flood device is on. Disconnect the appliance and close 29 the water tap. Contact the Authorised Service Centre. WARNING! Deactivate the appliance before carrying out any check. 14.2 Possible failures Problem Possible solution The programme does not start. • Make sure that the mains plug is connected to the mains socket.
www.aeg.com Problem Possible solution There is water on the floor. • Make sure that the couplings of the water hoses are tight and there is not water leakages. • Make sure that the water inlet hose and the drain hose have no damages. • Make sure you use the correct detergent and the correct quantity of it. You cannot open the appliance door. • Make sure that a washing programme that ends with water in tub, has been selected. • Make sure that the washing programme is finished.
ENGLISH 31 15. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant standards. Different causes can change the data: the quantity and type of laundry and ambient temperature. Water pressure, the supply voltage and the temperature of inlet water may also affect the washing programme duration. Technical specifications may be changed without prior notice to improve the quality of product.
www.aeg.com 16. TECHNICAL DATA Dimension Width/ Height/ Depth/ Total depth 600 mm/ 850 mm/ 571 mm/ 600 mm Electrical connection Voltage Overall power Fuse Frequency 230 V 2200 W 10 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply pressure 0.5 bar (0.05 MPa) 8 bar (0.
ENGLISH 33 17.2 Cleaning the drain pump filter 1 2 3 180˚ 1 2 Clean the filter regularly and, especially, if the alarm code display. appears on the 17.3 Programmes Programmes Load Product description 8 kg White cotton and coloured cotton. 8 kg White cotton and coloured cotton. Standard programmes for the Energy Label consumption values. Pflegeleicht 3 kg Synthetic items or mixed fabric items. Feinwäsche 3 kg Delicate fabrics such as acrylics, viscose, polyester items.
www.aeg.com Model Rated capacity in kg Energy efficiency class L6FB50489, PNC914913463 8 A+++ Energy consumption in kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used.
ENGLISH Airborne acoustical noise emission in db(A) spinning 78 Built in appliance Y/N No 35 The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC . 19. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances.
192942012-A-362018 www.aeg.
