L6FBG941R USER MANUAL EN User Manual Washing Machine
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION............................................................................................................6 4. PRODUCT DESCRIPTION.........................................................................................10 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
ENGLISH • • • • • • • electrical ratings of the mains power supply. Do not use multi-plug adapters and extension cables. Make sure not to cause damage to the mains plug and to the mains cable. Should the mains cable need to be replaced, this must be carried out by our Authorised Service Centre. Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation.
www.aeg.com 3. INSTALLATION WARNING! Refer to Safety chapters. 4. Open the door and remove the polystyrene piece from the door seal and all the items from the drum. 3.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance. WARNING! Use the gloves. 1. Use a cutter to cut through external film. 5. Carefully put down the appliance with the rear side on it. 6. Put the front polystyrene packaging element on the floor under the appliance. 2.
ENGLISH 7 Attach the sound barriers at a room temperature. 13. Pull up the appliance in vertical position. CAUTION! Do not use alcohol, solvents or chemical products. 9. Make sure to identify the different sizes and the positions of the sound barriers. Refer to the illustration: 14. Remove the power supply cable and the drain hose from the hose holders. A B • A (FRONT) = Front of the appliance • B (BACK) = Rear of the appliance 10. Remove the adhesive strip from the sound barriers. 11.
www.aeg.com We recommend that you keep the packaging and the transit bolts for any movement of the appliance. 3.2 Installation on suspended flooring Suspended wooden floors are particularly susceptible to vibration. To limit vibration we recommend placing a waterproof wooden panel, at least 15 mm thick, under the appliance. It should be screwed to at least 2 floor beams and should extend beyond the front feet. x4 The appliance must be level and stable.
ENGLISH 9 You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 45 20 O O Make sure that the inlet hose is not in vertical position. 3. If necessary, loose the ring nut to set it in the correct position. 4. Connect the water inlet hose to the cold water tap with 3/4" thread. 1. Make a U shape with the drain hose and put it around the plastic hose guide. 2.
www.aeg.com 5. Without the plastic hose guide, to a sink spigot - Put the drain hose in the spigot and tighten it with a clamp. Refer to the illustration. The end of the drain hose must always be ventilated , i.e. the inner diameter of the drain pipe (min. 38 mm min. 1.5") must be larger than the external diameter of the drain hose. 4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe.
ENGLISH 11 4.3 Appliance overview 1 2 9 8 3 10 4 5 11 12 6 7 1 2 3 4 5 6 7 Worktop Detergent dispenser Control panel Door handle Rating plate Drain pump filter Feet for levelling the appliance 8 9 10 11 12 Drain hose Inlet hose connection Mains cable Transit bolts Hose support 5. CONTROL PANEL 5.
www.aeg.com 1 Programme dial 2 Display 3 Eco touch button 4 Time Save touch button 5 Rinse touch button • Extra rinse option • Skipping wash phase Rinse only 6 Start/Pause touch button 7 Stains/Prewash touch button • Stains option • Prewash option Delay Start touch button Soft Plus touch button Spin reduction touch button Temperature touch button On/Off push button 8 9 10 11 12 5.2 Display MIX Maximum load indicator. The load estimation.
ENGLISH 13 Child safety lock indicator. Energy saving indicators. The indicator appears by selecting a programme for cotton at 40 °C or 60 °C. Temperature indicator. The set. indicator appears when a cold wash is Spin speed indicator. No spin speed indicator. Spin phase is off. Rinse hold indicator. Extra silent indicator. Time saving indicator. 6. DIAL AND BUTTONS 6.1 On/Off 6.3 Temperature Pressing this button for a few seconds allows to activate or deactivate the appliance.
www.aeg.com turns regularly to reduce creasing. You must drain the water to unlock the door. If you touch the Start/Pause button, the appliance performs the spinning phase and drains the water. The appliance empties the water out automatically after 18 hours approximately. • Activate the Extra Silent option. The intermediate and the final spinning phases are suppressed and the programme ends with water in the drum. This helps to reduce creasing. The display shows the indicator . The door stays locked.
ENGLISH If you select the Cotton programme at 40°C or 60°C and no other options are set, the display shows the ; these are indicator the standard cotton programmes, the most efficient programmes in terms of combined energy and water consumption. 6.8 Time Save With this option you can decrease the programme duration. • If your laundry is normally or lightly soiled, it may be advisable to shorten the washing programme. Touch this button once to decrease the duration.
www.aeg.com Programme Programme description Synthetic items or mixed fabric items. Normal soil. Synthetics Delicates Delicate fabrics such as acrylics, viscose and mixed fabrics requiring a mild washing. Normal soil. Machine washable wool, hand washable wool and other Wool/Silk Anti-Allergy fabrics with «hand washing» care symbol1). White cotton items. This programme removes micro-organisms thanks to a washing phase with the temperature maintained above 60°C for some minutes.
ENGLISH 17 Programme Programme description Drain/Spin To spin the laundry and to drain the water in the drum. All fabrics, except woollens and delicate fabrics. 1) During this cycle the drum rotates slowly to ensure a gentle wash. It can seem that the drum doesn't rotate or doesn't rotate properly, but this is normal for this programme. 2) To reduce creasing, this cycle regulates the water temperature and performs a soft wash and spin phase. The appliance adds some rinses.
www.aeg.com Outdoor Duvet Easy Iron Drain/Spin ■ 20 min.
ENGLISH 19 8. SETTINGS 8.1 Child Lock With this option you can prevent children from playing with the control panel. • To activate/deactivate this option, touch the Spin and the Stain/Prewash buttons simultaneously until the indicator comes on/goes off on the display. You can activate this option: • After you touch the Start/Pause button: all the buttons and the programme dial are deactivated (except On/Off button ). • Before you touch the Start/Pause button: the appliance cannot start.
www.aeg.com 4. Close the door firmly. Always follow the instructions that you find on the packaging of the detergent products, but we recommend that you do not exceed the maximum indicated level ( ). This quantity will however guarantee the best washing results. CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 10.
ENGLISH 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. 21 The indicator of the Start/Pause button flashes.
www.aeg.com Changing the delay start after the countdown has started 10.9 Programme phase indicators To change the delay start: When the programme starts the indicator of the running phase flashes and the other phase indicators are steady on. 1. Touch the Start/Pause button to pause the appliance. The related indicator flashes. 2. Touch the Delay Start button repeatedly until the display shows the desired delay time. 3. Touch the Start/Pause button again to start the new countdown. E.g.
ENGLISH 10.12 Opening the door If the temperature and level of the water in the drum are too high and/or the drum still rotates you cannot open the door. While a programme or the delay start operates, the appliance door is locked. 1. Touch the button Start/Pause. In the display the related door lock indicator goes off. 2. Open the appliance door. If necessary, add or remove the items. 3. Close the door and touch the button Start/Pause. The programme or the delay start continues. 10.
www.aeg.com Press the On/Off button to activate the appliance again. The display shows the end of the last set programme. Turn the programme dial to set a new cycle. If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drain the water. 11. HINTS AND TIPS WARNING! Refer to Safety chapters. 11.1 The laundry load • Divide the laundry into: white, coloured, synthetics, delicates and wool.
ENGLISH • Always start a washing programme with the maximum load of laundry allowed. • If you pre-treat the stains, you can use a stain remover when you set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness". 25 additive for water softening. In areas where the water hardness is soft it is not necessary to use him. To find out the water hardness in your area, contact your local water authority.
www.aeg.com For a complete cleaning: 1. Clean the drum with special products for stainless steel. Always follow the instructions that you find on the packaging of the product. 2. Run a short cotton programme at high temperature or use if is available programme Machine Clean. Add a small quantity of powder detergent into empty drum, in order to rinse out any left residues. 12.6 Cleaning the detergent dispenser 3.
ENGLISH Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code without removing. Let the water flow out. . WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to clean the pump: 1. Open the pump cover. 2 1 2.
www.aeg.com 10. Clean the filter under the water tap. 1 2 3 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 2. Remove the inlet hose from the appliance by loosening the ring nut. 3. Clean the valve filter on the back of the appliance with a toothbrush. 12. Close the pump cover. 2 1 12.
ENGLISH 29 values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 45° 20° 12.9 Emergency drain 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Put the two ends of the inlet hose in a container and let the water flow out of the hose. 4. Empty the drain pump. Refer to the emergency drain procedure. 5. When the drain pump is empty, install the inlet hose again.
www.aeg.com WARNING! Deactivate the appliance before carrying out any check. 13.2 Possible failures Problem The programme does not start. The appliance does not fill with water properly. Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed. • Make sure that there is no damaged fuse in the fuse box. • Make sure that the Start/Pause has been touched.
ENGLISH 31 Problem Possible solution There is water on the floor. • Make sure that the couplings of the water hoses are tight and there is not water leakages. • Make sure that the water inlet hose and the drain hose have no damages. • Make sure you use the correct detergent and the correct quantity of it. You cannot open the appliance door. • Make sure that a washing programme that ends with water in tub, has been selected. • Make sure that the washing programme is finished.
www.aeg.com 14. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant standards. Different causes can change the data: the quantity and type of laundry and ambient temperature. Water pressure, the supply voltage and the temperature of inlet water may also affect the washing programme duration. Technical specifications may be changed without prior notice to improve the quality of product.
ENGLISH 33 15.
www.aeg.com using the correct stacking kit manufactured and approved by AEG. Verify the compatible stacking kit by checking the depth of your appliances. Read carefully the instructions supplied with the appliance and with the accessory. WARNING! Do not put the tumble dryer under the washing machine. The stacking kit can be used only with the appliances specified in the leaflet provided with the accessory. 17. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol .
ENGLISH 35
192947761-A-212017 www.aeg.
