L6FBI842N USER MANUAL EN User Manual Washing Machine
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION............................................................................................................6 4. PRODUCT DESCRIPTION.........................................................................................10 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • • • The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.
ENGLISH 2.2 Electrical connection • The appliance must be earthed. • Always use a correctly installed shockproof socket. • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Do not use multi-plug adapters and extension cables. • Make sure not to cause damage to the mains plug and to the mains cable. Should the mains cable need to be replaced, this must be carried out by our Authorised Service Centre.
www.aeg.com 3. INSTALLATION WARNING! Refer to Safety chapters. 4. Open the door and remove the polystyrene piece from the door seal and all the items from the drum. 3.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance. WARNING! Use the gloves. 1. Use a cutter to cut through external film. 5. Carefully put down the appliance with the rear side on it. 6. Put the front polystyrene packaging element on the floor under the appliance.
ENGLISH 9. Remove the power supply cable and the drain hose from the hose holders. It is possible to see water flowing from the drain hose. This is due to the testing with water of the appliance in factory. 7 We recommend that you keep the packaging and the transit bolts for any movement of the appliance. 3.2 Installation on suspended flooring Suspended wooden floors are particularly susceptible to vibration.
www.aeg.com 45 20 O O x4 The appliance must be level and stable. A correct adjustment of the appliance level prevents the vibration, noise and the movement of the appliance when in operation. Make sure that the inlet hose is not in vertical position. 3. If necessary, loose the ring nut to set it in the correct position. 4. Connect the water inlet hose to the cold water tap with 3/4" thread. 3.4 The inlet hose 1. Connect the water inlet hose to the back of the appliance. 2.
ENGLISH 9 4. If the end of the drain hose looks like this (see the picture), you can push it directly into the stand pipe. 2. On the edge of a sink - Fasten the guide to the water tap or to the wall. Make sure that the plastic guide cannot move when the appliance drains. 5. Without the plastic hose guide: Put the drain hose in the spigot and tighten it with a clip. Refer to the illustration. Make sure that the drain hose end is not immersed in the water.
www.aeg.com 4. PRODUCT DESCRIPTION 4.
ENGLISH 11 5. CONTROL PANEL 5.1 Control panel description 2 1 3 Programme Delay Start Cottons Cotton Eco Synthetics Delicates Wool/Silk 20 min. - 3kg Cotton 20° Duvet Easy Iron Drain/Spin 1400 95° Time Save 800 No spin 30° Temp.
www.aeg.com A The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. or ). ). • Cycle end ( ). • Warning code ( ). B Extra rinse indicator. It lights on when this option is selected . C The tions. D Child safety lock indicator. E Door locked indicator. indicator blink during the laundry load detec- 6. DIAL AND BUTTONS 6.1 On/Off 6.3 Temp. Pressing this button for a few seconds allows to activate or deactivate the appliance.
ENGLISH The appliance empties the water out automatically after 18 hours approximately. Activate the No spin option • Set this option to deactivate all spin phases. Only the drain phase is available. • The related indicator comes on. • Set this option for very delicate fabrics. • The rinses phase uses more water for some washing programmes. The spin speed can be reduce. 6.5 Options Press this button repeatedly to activate one of the available options.
www.aeg.com 7. PROGRAMMES 7.1 Programme Chart Washing programmes Programme Programme description Washing programmes Cottons Cotton Eco White cotton and coloured cotton. Normal soil and light soil. White and coloured cotton White cotton and coloured cotton. Normal soil and light soil. Standard programmes for the Energy Label consumption values.
ENGLISH 15 Programme Programme description Drain/Spin To spin the laundry and to drain the water in the drum. All fabrics, except woollens and delicate fabrics. 1) During this cycle the drum rotates slowly to ensure a gentle wash. It can seem that the drum doesn't rotate or doesn't rotate properly, but this is normal for this programme. 2) This programme is for daily use and has the lowest energy and water consumption whilst maintaining a good washing performance.
www.aeg.com Delicates Wool/Silk 20 min.
ENGLISH 17 Time Save buttons simultaneously for about 6 seconds. indicator comes on/goes off on the display. You can activate this option: • After you touch the Start/Pause button: all the buttons and the programme dial are deactivated (except On/Off button ). • Before you touch the Start/Pause button: the appliance cannot start. The appliance keeps the selection of this option after you switch it off. 8.
www.aeg.com CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 10.3 Filling the detergent and additives 10.4 Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dispenser. 1 2 3. To use powder detergent, turn the flap up. Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase.
ENGLISH With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. 19 10.6 Starting a programme with the delay start Touch the Start/Pause button. The appliance starts the countdown of the delay start.
www.aeg.com 10.8 The ProSense load detection After touching the Start/Pause button the ProSense technology starts the laundry load detection: 1. The appliance detects the load within a few minutes, the indicator blink, the drum rotates shortly. 2. At the end of the load detection, the indicator goes off . About 20 minutes after the programme start, the programme duration could be adjusted depending on the capacity of water absorption of the fabrics.
ENGLISH 2. 3. 4. 5. When you activate the appliance again, the display show the end of the last selected programme. Turn the programme dial to set a new cycle. Remove the laundry from the appliance. Make sure that the drum is empty. Keep the door and the detergent dispenser slightly ajar to prevent mildew and odours. Close the water tap. 10.
www.aeg.com • Do not wash laundry without hems or with cuts. Use a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). • A very small load can cause balance problems with the spin phase leading to excessive vibration. If this occurs: a. interrupt the programme and open the door (refer to "Opening the door when a programme or the delay start operates"); b. manually redistribute the load so that the items are spaced evenly around the tub; c.
ENGLISH CAUTION! Do not use alcohol, solvents or chemical products. CAUTION! Do not clean the metal surfaces with chlorine-based detergent. 12.2 Descaling If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines. Regularly examine the drum to check any limescale. The regular detergents already contain water softening agents, but we recommend to run a cycle with empty drum and a descaling product occasionally.
www.aeg.com Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code . 3. Make sure that all detergent residue is removed from the upper and lower part of the recess. Use a small brush to clean the recess. WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot.
ENGLISH 5. When the bowl is full of water, close the drainage duct back and empty the container. 6. Repeat the steps 4 and 5 until the water stops to flowing out. 25 10. Clean the filter under the water tap. 2 1 7. Close the drainage duct and turn the filter anti-clockwise to remove it. 2 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 2 1 1 12. Close the pump access. 8.
www.aeg.com 12.8 Cleaning the inlet hose and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 4. When you reconnect the hose to the back of the appliance, turn it left or right (not in vertical position) depending on the position of your water tap. 1. Remove the inlet hose from the tap and clean the filter. 1 45° 20° 2 3 2. Remove the inlet hose from the appliance by loosening the ring nut. 12.
ENGLISH 27 13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. In case of major problems, the acoustic signals operate, the display shows an alarm code and the Start/Pause button may flash continuously: • - The appliance does not fill with water properly.
www.aeg.com Problem The appliance does not fill with water properly. Possible solution • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. • Make sure that the inlet hose has no kinks, damages or bends. • Make sure that the connection of the water inlet hose is correct.
ENGLISH 29 Problem Possible solution The appliance makes an unusual noise and vibrates. • Make sure the levelling of the appliance is correct. Refer to 'Installation instruction'. • Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation instruction'. • Add more laundry in the drum. The load may be too small. The programme duration • The ProSense function is able to adjust the programme duincreases or decreases ration according to the type and the laundry load size.
www.aeg.
ENGLISH Energy Efficiency Class Spin Speed 31 A+++ -20% Maximum 1400 rpm 1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your domestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the appliance inlet hose and the bottom of the water storage tank.
www.aeg.com 17. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances * marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
ENGLISH 33
www.aeg.
ENGLISH 35
192946800-A-022017 www.aeg.
