L 70260 TL 1 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ACCESSORIES . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH ance. Contact the Service to ensure which accessories can be used. Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.
www.aeg.com 3. PRODUCT DESCRIPTION 1 7 2 8 9 3 10 11 4 5 6 12 1 Control panel 7 Rating plate 2 Lid 8 Mains cable 3 Lid button 4 Filter access door 9 Water inlet valve 10 Water drain hose 5 Lever to move the appliance 11 Transit bolts 6 Adjustable feet 12 Feet for the appliance level 4. ACCESSORIES 1 2 3 1 Plastic cap To close the hole on the rear side of the cabinet, after the removal of the transit bolt. 2 Plastic hose guide To connect the drain hose on the edge of a sink.
ENGLISH 7 5. CONTROL PANEL 1 2 3 10 1 On/Off button 2 Programme knob 3 Display 4 5 6 Start/Pause button Delay start button Time saving button 7 Liquid detergent button 8 9 10 Stain button Spin button Temperature button 5.1 On Off button 1 9 8 7 6 5 4 The AUTO Stand-by function automatically deactivates the appliance to decrease the energy consumption when: • You do not use the appliance for 5 minutes before you press button 4 . – All settings are cancelled.
www.aeg.com B • The default spin speed of the programme. • 'No Spin'1) and 'Rinse Hold' symbols. C • The display symbols.2) Symbols Description Washing phase Rinse phases Spin phase Child lock Extra rinse You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off. If the programme is completed but the symbol stays on: • There is water in the drum. • The 'Rinse Hold' function is on.
ENGLISH 5.6 Time save button 6 5.10 Temperature button 10 Press the button 6 to decrease the programme duration. • Press one time to set 'Shortened duration' for items with daily soil. • Press two times to set 'Extra Quick' for items with almost no soil. Press button 10 to change the default temperature. Some programmes accept only one of the two functions. 5.7 Liquid detergent button 7 Press button 7 to adapt the cycle if you use a liquid detergent. 5.
www.aeg.com 6. WASHING PROGRAMMES Programme Temperature Type of load Cycle max. weight of load description Functions Cottons 95° - Cold White and coloured cotton with normal soil. max. 6 kg Wash Rinses Long spin SPIN REDUCTION RINSE HOLD STAIN1) LIQUID DETERGENT EXTRA RINSE TIME SAVE2) White and coloured cotton with heavy soil. max.
ENGLISH Programme Temperature Type of load Cycle max. weight of load description Functions Delicates 40° - Cold Delicate fabrics as Wash acrylics, viscose, pol- Rinses yester items with nor- Short spin mal soil. max. 2,5 kg SPIN REDUCTION RINSE HOLD STAIN1) LIQUID DETERGENT EXTRA RINSE TIME SAVE2) Machine washable Wash wool. Hand washable Rinses wool and delicate Short spin fabrics with «hand washing» care symbol. max.
www.aeg.com Programme Temperature Type of load Cycle max. weight of load description Functions Quick washing programme, to be used for lightly soiled white/fast coloured cottons and mixed fabrics. max. 2,5 kg Wash Rinses Long spin SPIN REDUCTION RINSE HOLD LIQUID DETERGENT EXTRA RINSE 20 Min. - 3 kg 40° - 30° Cotton and synthetic items with light soil or worn only one time. Wash Rinses Short spin SPIN REDUCTION LIQUID DETERGENT Super Eco6) Cold Mixed fabrics (cotton Wash and synthetic items).
ENGLISH 6.1 Woolmark Certificate The wool wash cycle of this machine has been approved by The Woolmark Com- 13 pany for the washing of machine washable Woolmark product provided that the garments are washed according to the instructions on the garment label and those issued by the manufacturer of this washing machine. M1027 In UK, Eire, Hong Kong and India the Woolmark symbol is a certification trademark. 7. CONSUMPTION VALUES The data of this table are approximate.
www.aeg.com 8. BEFORE FIRST USE Put a small quantity of detergent in the main wash compartment of the detergent dispenser. Set and start a programme for cotton at the highest tem- perature without laundry. This removes all possible dirt from the drum and the tub. 9. USING THE APPLIANCE 1. 2. Open the water tap. Connect the mains plug to the mains socket. 3. Press button 1 to activate the appliance. 4. Put the laundry in the appliance. 5. Use the correct quantity of detergent and additives. 6.
ENGLISH 15 Detergent compartment for washing phase. The marks MAX are the maximum levels for the quantity of detergent (powder or liquid). Compartment for liquid additives (fabric conditioner, starch). The mark M is the maximum level for the quantity liquid additives. Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. CLICK A 3. 4. CLICK B • Position A for powder detergent (factory setting). • Position B for liquid detergent.
www.aeg.com The drain pump can operate for a short time when the appliance fills water. 9.4 Interrupt a programme 1. Press button 4 . The indicator flashes. 2. Press button 4 again. The washing programme continues. 9.5 Cancel a programme 1. Press button 1 to cancel the programme and to deactivate the appliance. 2. Press button 1 again to activate the appliance. Now, you can set a new washing programme. The appliance does not drain the water. 9.
ENGLISH • Remove the laundry from the appliance. Make sure that the drum is empty. • Keep the door ajar, to prevent mildew and odours. • Close the water tap. The washing programme is completed, but the 'Rinse Hold' function is on: – The drum turns regularly to prevent the creases in the laundry. – The door stays locked. – You must drain the water to open the door. 17 To drain the water: 1. If necessary, decrease the spin speed. 2. Press the Start/Pause button 4 .
www.aeg.com • Always start a washing programme with the maximum load of laundry. • If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of the detergent, check the water hardness of your domestic system 10.5 Water hardness If the water hardness in your area is high or moderate, we recommend that you use a water softener for washing machines. In areas where the water hard- ness is soft it is not necessary to use a water softener.
ENGLISH 19 11.4 Detergent dispenser To clean the dispenser: Remove the detergent dispenser and disconnect the two parts. 2. Clean all the parts with water. 3. Assemble the two parts of the detergent dispenser. 4. Put back the detergent dispenser. 1. WARNING! • Disconnect the mains plug from the mains socket. • Do not remove the filter while the appliance operates. Do not clean the drain filter if the water in the appliance is hot. The water must be cold before you clean the drain filter. 11.
www.aeg.com 11.6 The inlet hose filter and the valve filter WARNING! • Disconnect the mains plug from the mains socket. To clean the water inlet filters: Close the water tap. Remove the water inlet hose from the water tap. 3. Clean the filter in the inlet hose with a stiff brush. 1. 2. 4. 5. 6. 7. Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages.
ENGLISH 2. Put the end of the inlet hose in a container and let the water flow out of the hose. 3. Do the Drain programme and let it operate until the end of the cycle. 4. Turn the programme knob to Stop to disconnect the appliance from the power supply. 5. 21 Disconnect the appliance. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 12.
www.aeg.com Problem Possible cause Possible solution A washing programme without the drain phase is set. Set the drain programme. The function Rinse & Hold is on. Set the drain programme. The appliance door is open or not closed correctly. Close the door correctly. The anti-flood device is on. • Disconnect the appliance. • Close the water tap. • Contact the service centre. The spin phase does not operate. The programme does not start. There is water on the floor. The spin phase is off.
ENGLISH 23 Problem Possible cause The appliance makes an unusual noise. Incorrect level of the ap- Adjust the level of the applipliance. ance. Refer to 'Installation'. Possible solution You did not remove the packaging and/or the transit bolts. Remove the packaging and/or the transit bolts. Refer to 'Installation'. The load is very small. Add more laundry in the drum. The appliance fills The end of the drain with water and hose is too low. drain immediately.
www.aeg.com Spin speed Maximum 1200 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 14. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
ENGLISH 25
www.aeg.
ENGLISH 27
108805700-A-462012 www.aeg.
