User manual

Problem Possible cause Possible solution
A washing programme
without the drain phase
is set.
Set the drain programme.
The function Rinse &
Hold is on.
Set the drain programme.
The appliance
door is open or
not closed cor-
rectly.
Close the door correctly.
The anti-flood de-
vice is on.
• Disconnect the appliance.
• Close the water tap.
• Contact the service centre.
The spin phase
does not operate.
The spin phase is off. Set the spin programme.
The filter of the drain
pump is blocked.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Balance problems with
the laundry load.
Adjust manually the items in the
tub and start the spin phase
again.
The programme
does not start.
The mains plug is not
connected in the mains
socket.
Put in the mains plug.
Blow out fuse in the
household fuse box.
Replace the fuse.
You did not press but-
ton
4
.
Press button
4
.
The delay start is set. To start immediately the pro-
gramme, cancel the delay start.
The Child Lock function
is activated.
Deactivate the Child Lock func-
tion.
There is water on
the floor.
Leakages from the cou-
plings of the water ho-
ses.
Make sure that the couplings
are tight.
Leakages from the drain
pump.
Make sure that the drain pump
filter is tight.
The water drain hose is
damaged.
Make sure that the water inlet
hose has no damages.
You cannot open
the appliance
door.
The washing pro-
gramme is in operation.
Let the washing programme
end.
There is water in the
drum.
Set the drain or the spin pro-
gramme.
22
www.aeg.com