L 71260 SL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 6 7 1 Worktop 2 Detergent dispenser 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 4.
ENGLISH 7 4.1 Display A B C A) The temperature area: – : Temperature indicator – : Cold water indicator. B) The spin area: – : the Spin speed indicator – : the No Spin indicator1) – : the Rinse Hold indicator. C) The display indicators: – : the washing phase – – : the spin phase – : the child safety lock – : the Door locked – : the delay start.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Lana/Seta 40°C – Cold Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol. 2 kg, 1200 rpm Centrifuga/Scarico To spin the laundry and to drain the water in the drum. All fabrics. 6 kg, 1200 rpm Risciacquo Cold To rinse and spin the laundry. All fabrics. 6 kg, 1200 rpm Tende 40°C - Cold Special programme for curtains. The prewash phase activates automatically.
ENGLISH Programme Cotoni + Prelavaggio ■ ■ Extra Silent 9 Macchie Extra Risciacquo Risparmio Tempo Partenza Ritardata ■ ■ ■ ■ ■ ■ ■ ■ Sintetici ■ ■ ■ ■ ■ ■ Sintetici + Prelavaggio ■ ■ ■ ■ ■ ■ Stiro Facile ■ ■ ■ ■ ■ Delicati ■ ■ ■ ■ ■ ■ ■ Lana/Seta ■ ■ Centrifuga/Scarico1) ■ ■ ■ Risciacquo ■ ■ ■ ■ Tende ■ ■ ■ ■ Jeans ■ Rapido ■ ■ ■ ■ 20 Min.
www.aeg.com Programmes Load (Kg) Energy con- Water consumption sumption (li(kWh) tre) Approximate programme duration (minutes) Remaining moisture (%)1) Cottons 60 °C 6 1.00 56 146 53 Cottons 40 °C 6 0.75 56 145 53 Synthetics 40 °C 3 0.47 45 127 35 Delicates 40 °C 3 0.65 62 100 35 Wool 30 °C 2 0.25 55 56 30 Standard cotton programmes Standard 60 °C cotton 6 0.80 49 169 53 Standard 60 °C cotton 3 0.70 40 154 53 Standard 40 °C cotton 3 0.
ENGLISH regularly to prevent the laundry creases. • The door stays locked. You must drain the water to unlock the door. • The display shows the indicator . To drain the water refer to ‘At the end of the programme’. 7.3 Stain (Macchie) Set this option to add the stain phase to a programme. Use this option for laundry with hard stains to remove. When you set this option, put the stain . remover into compartment This option increases the programme duration.
www.aeg.com 8. BEFORE FIRST USE Put 2 litre of water in the detergent compartment for washing phase. This activates the drain system. 2. Put a small quantity of detergent in the compartment for washing phase. 1. 3. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. 9. DAILY USE 9.1 Loading the laundry 1. 2. Open the appliance door. Put the laundry in the drum, one item at a time.
ENGLISH 13 Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.3 Activating the appliance Press On/Off to activate or deactivate the appliance. A tune sounds when the appliance is activated. 9.4 Setting a programme 1.
www.aeg.com 9.5 Starting a programme without delay start Press Avvio/Pausa: • The indicator Avvio/Pausa stops to flash and stays on. • The indicator starts to flash on the display. • The programme starts, the door is locked and the display shows the indicator . • The drain pump can operate for a short time when the appliance fills water. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load.
ENGLISH 3. 4. Close the appliance door. Set the programme again. 9.11 At the end of the programme • The appliance stops automatically. • The acoustic signal operates (if it is activated). • In the display a comes on. • The indicator Avvio/Pausa goes off. • The door lock indicator goes off. • Remove the laundry from the appliance. Make sure that the drum is empty. • Keep the door ajar, to prevent the mildew and odours. • Close the water tap. • Press On/Off for some seconds to deactivate the appliance.
www.aeg.com – Use a washing bag to wash small items. • A very small load can cause balance problems with the spin phase. If this occurs, adjust manually the items in the tub and start the spin phase again. • If your appliance has not the detergent dispenser with the flap device, add the liquid detergents with a dosing ball. 10.2 Stubborn stains • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry.
ENGLISH 11.3 Maintenance wash With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: • Remove the laundry from the drum. • Set the cotton programme with the highest temperature with a small quantity of detergent. 11.4 Door seal Regularly examine the seal and remove all objects from the inner part. 11.5 Cleaning the detergent dispenser 1. 2. 3. 4. 11.
www.aeg.com 1. 2. 1 1 2 3. 4. 2 1 5. 6. 1 7. 2 8.
ENGLISH 19 9. 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 45° 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
www.aeg.com 1. 2. 3. 4. 5. Disconnect the mains plug from the mains socket. Close the water tap. Remove the water inlet hose. Put the two ends of the inlet hose in a container and let the water flow out of the hose. Empty the drain pump. Refer to the emergency drain procedure. 6. When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again.
ENGLISH Problem 21 Possible solution Make sure that the filter of the inlet hose and the filter of the valve are not clogged. Refer to “Care and cleaning”. Make sure that the inlet hose has no kinks or bends. Make sure that the connection of the water inlet hose is correct. The appliance does not drain the water. Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary.
www.aeg.com Problem Possible solution The appliance fills with water and drain immediately. Make sure that the drain hose is in the correct position. The hose may be too low. The cycle is shorter than the time displayed. The appliance calculates a new time according to the laundry load. See the ‘Consumption Values’ chapter. The cycle is longer than the time displayed. An unbalanced laundry load increases the duration time. This is a normal behavior of the appliance.
ENGLISH 14. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
132913890-A-252013 www.aeg.
