User manual

24
Programme progress display
By selecting the wash programme, the pilot lights corre-
sponding to the various phases making up the programme
come on. After the machine has started, only the running
phase pilot light stays on.
Display
The time to the end of the programme decreases minute by minute and
appears on the display.
At the end of the programme
The machine stops automatically. A zero appears on the display. An
acoustic signal is clearly audible. The END light (FIN) comes on in the
programme progress display.
If the light SOBREDOSIFICACION (OVERDOSAGE) comes on it indicates
that too much detergent has been used. At the next wash carefully fol-
low the detergent manufacturer’s instructions. Measure out detergent
according to amount, type, degree of soil of fabrics and water hardness.
This light could come on also when the drain filter is blocked.
If the RINSE HOLD (AGUA EN LA CUBA) option has been selected, the
water must be emptied out before opening the door either
- by pressing the START/PAUSE button (the laundry will be spun at the
speed corresponding to the selected type of fabrics. The spin speed
can be reduced by means of the SPIN SPEED button)
- or by turning the selector dial to ANULACION and then to DRAIN
(DESCARGA) and pressing the START/PAUSE button again. In this case
the water will be emptied, but the laundry is not spun.
Turn the selector dial to ANULACION.
Remove the laundry from the drum.
Check that the drum is empty so as to avoid any forgotten items
being damaged in a subsequent wash (e.g. shrinking) or their colour
running into a load of whites.
Close the water tap.
Leave the door open to prevent the formation of mildew and unpleas-
ant smells.
How to wash
PRELAVADO
LAVADO
ACLARADOS
ACLARADO
ADICIONAL
CENTRIFUGADO
FIN
PREWASH
WASH
RINSES
EXTRA
RINSE
SPIN
END
SOBRE-
DOSIFICACION
OVER-
DOSAGE
132997890.qxd 01/06/01 10.57 Pagina 24 (Nero/Process Black pellicola)