L 73481 FL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 6 7 1 Worktop 2 Detergent dispenser 4. CONTROL PANEL 1 2 Algod. Eco 3 Algod.
ENGLISH 7 4.1 Display A B C A) The temperature area: – : Temperature indicator – : Cold water indicator. B) The spin area: – : the Spin speed indicator – : the No Spin indicator1) – : the Rinse Hold indicator. C) The display indicators: – : the washing phase – – : the spin phase – : the child safety lock – : the Door locked – : the delay start.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Fácil1) Synthetics Easy Iron 60°C - Cold Synthetic fabric items. Normal soil and light soil. 3 kg, 1000 rpm Delicados Delicates 40°C - Cold Delicate fabrics as acrylics, viscose, polyester items. Normal soil and light soil. 3 kg, 1200 rpm Lana / Lã Wool/Silk 40°C - Cold Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol. 2 kg, 1200 rpm Centrif.
ENGLISH 9 The water temperature of the washing phase may differ from the temperature declared for the selected programme. Manchas/Nódoas Extra Aclarado/Enxag. Extra Rapido Inicio Diferido Programme options compatibility Algod. ■ ■ ■ ■ ■ ■ Algod. + Prelava. ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Programme Extra silencio Sintéticos ■ ■ ■ ■ ■ ■ Sintéticos + Prelava. ■ ■ ■ ■ ■ ■ Fácil ■ ■ ■ ■ ■ Delicados ■ ■ ■ ■ ■ ■ ■ Lana / Lã ■ ■ Centrif.
www.aeg.com 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can greatly be reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 8 kg, the programme duration exceeds 2 hours; real load 1 kg, the programme duration don’t reach 1 hour).
ENGLISH 11 7. OPTIONS 7.1 Temperature (Temp.) Set this option to change the default temperature. = cold water. Indicator The indicator of the set temperature comes on. 7.2 Spin (Centrif.) With this option you can decrease the default spin speed. The display shows the indicator of the set speed. Additional spin options: No Spin • Set this option to remove all spin phases. • Set it for very delicate fabrics. • The rinse phase uses more water for some washing programmes. • The display shows the indicator .
www.aeg.com at the same time until the indicator Extra Aclarado/Enxag. comes on/goes off. 7.9 Acoustic signals The acoustic signals operate when: • You activate the appliance. • You deactivate the appliance. • You press the buttons. • The programme is completed. • The appliance has a malfunction. To deactivate/activate the acoustic signals, press Manchas/Nódoas and Extra Aclarado/Enxag. at the same time for 6 seconds.
ENGLISH 9.2 Using detergent and additives • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. 1 A 2 3. 4.
www.aeg.com • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 9.
ENGLISH 9.8 Cancelling a programme Press On/Off for some seconds to cancel the programme and to deactivate the appliance. 2. Press the same button again to activate the appliance. Now, you can set a new washing programme. 1. The appliance does not drain the water. 9.9 Changing the options You can change only some options before they operate. 1. Press Inicio/Pausa. The related indicator flashes. 2. Change the options. 3. Press Inicio/Pausa again. The programme continues. 9.
www.aeg.com Press the button On/Off to activate the appliance again. • After 5 minutes from the end of the washing programme Press the button On/Off to activate the appliance again. The display shows the end of the last set programme. Turn the programme knob to set a new cycle. 10. HELPFUL HINTS AND TIPS 10.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels.
ENGLISH chines. In areas where the water hardness is soft it is not necessary to use a water softener. To know the water hardness in your area, contact your local water authority. 17 Use the correct quantity of the water softener. Obey the instructions that you find on the packaging of the product. 11. CARE AND CLEANING WARNING! Before maintenance, disconnect the appliance from the mains supply. 11.1 External cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces.
www.aeg.com 11.5 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 1. 2.
ENGLISH 3. 4. 2 1 5. 6. 1 7. 2 8. 1 2 9.
www.aeg.com 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain 1. Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH 21 12. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. • - The appliance door is open or not closed correctly. Please check the door! Problem • - The mains supply is unstable.
www.aeg.com Problem Possible solution Make sure that the connection of the drain hose is correct. Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'.
ENGLISH Problem 23 Possible solution Make sure that you set the correct temperature. Decrease the laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Service. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Service. 13.
132913961-A-332013 www.aeg.