User manual

D The programme time
When the programme starts, the time decreases with steps of 1 minute.
The delay start
When you press the delay start button, the display shows the delay start
time.
•Alarm codes
If the appliance has a malfunction, the display shows alarm codes. Refer
to 'Trouble Shooter' chapter.
•Err
The display shows this message for some seconds if:
You set a function that is not applicable for the programme.
You change the programme while it operates.
The indicator of the Start/Pause button
4
flashes.
When the programme is completed.
1)
Only available for Spin/Drain programme.
2)
The symbols appear on the display when the related phase or function is set.
START/PAUSE BUTTON
4
Press button
4
to start or interrupt a
programme.
DELAY START BUTTON
5
Press button
5
to delay the start of a
programme from 30 minutes to 20
hours.
TIME SAVE BUTTON
6
Press the button
6
to decrease the
programme duration.
Press one time to set 'Shortened du-
ration' for items with daily soil.
Press two times to set 'Extra Quick'
for items with almost no soil.
Some programmes accept only
one of the two functions.
EXTRA RINSE BUTTON
7
Press button
7
to add rinsing phases
to a programme.
Use this function for persons allergic to
detergents and in areas where the wa-
ter is soft.
STAIN BUTTON
8
Press button
8
to add the stain phase
to a programme.
Use this function for laundry with hard
stains to remove.
When you set this function, put the
stain remover into compartment
.
This function increases the pro-
gramme duration.
This function is not available
with a temperature lower than
40° C.
SPIN BUTTON
9
Press this button to:
Decrease the maximum speed of the
spin phase when you set a pro-
gramme.
The display shows only the spin
speeds available with the set
programme.
Deactivate the spin phase.
Activate the 'Rinse Hold' function.
Set this function to prevent fabric
creases. The appliance does not
drain the water when the programme
is completed.
ENGLISH 9