User manual

The display shows the door locked
indicator . The drying indicator
starts to flash.
You cannot set all dryness
levels for any type of
laundry.
11.3 Timed Drying
The laundry can also be dried with a
manual timed drying:
1. Press Minuterie again and again to
set the time value (see the
«Programmes for timed drying»
table).
• The display shows the set time
value: e.g. . Each time you
press this button the time value
increases by 5 minutes.
• After some seconds the display
shows a new time value: e.g. .
The appliance calculates also the
duration of the anti-crease and
the cooling phases.
2. Press Départ/Pause to start the
programme.
• The display shows regularly a new
time value.
• The drying indicator
starts to
flash.
• The display shows the door
locked indicator .
If you set only 10 minutes of
drying, the appliance
performs only a cooling
phase.
If the laundry is not sufficient
dry, set again a short drying
time.
11.4 End of the drying
programme
The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display
comes on.
• The indicator Départ/Pause goes off.
• The last minutes of the drying cycle
the appliance performs a cooling and
anti-crease phase. The door is still
locked.
When the door locked goes off in
the display, you can open the door.
1. Press the button Marche/Arrêt for
some seconds to deactivate the
appliance.
After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent
mildew and odours.
12.
DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
12.1 Non-Stop programme
1. Press Marche/Arrêt for some seconds
to activate the appliance.
2. Load the laundry one item at a time.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives
in the appropriate compartment.
4. Turn the programme dial to the
washing programme.
The display shows the indicators of the
different washing phases.
5. Set the available options.
12.2 Washing & Automatic
drying
1. Press Niveau Séchage again and
again until the display shows one of
the dryness level indicator:
ENGLISH 21