User manual

After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent
mildew and odours.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
12.1 Non-Stop programme
1. Press Marche/Arrêt for some seconds
to activate the appliance.
2. Load the laundry one item at a time.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives
in the appropriate compartment.
4. Turn the programme dial to the
washing programme.
The display shows the indicators of the
different washing phases.
5. Set the available options.
12.2 Washing & Automatic
drying
1. Press Niveau séchage again and
again until the display shows one of
the dryness level indicator:
• : IRON DRY level indicator for
cotton items
•
: CUPBOARD DRY level
indicator for cotton and synthetic
items
• : EXTRA DRY level indicator
for cotton items
The display shows the indicator
. The
time value on the display is the duration
of the washing + drying cycles,
calculated on a default load size.
To have a good drying the
appliance does not let you
set a too low spin speed for
the items to be washed and
dried.
2. Press Départ/Pause to start the
programme.
In the display the indicator of the set
dryness level stays on.
The door locked indicator goes on.
The display shows regularly a new time
value.
The last minutes of the
drying cycle the appliance
performs the anti-crease and
the cooling phases.
12.3 Washing & Timed Drying
To have a good drying the appliance
does not let you set a too low spin speed
for the items to be washed and dried.
1. Press Minuterie to set the drying time
value. The display shows 10 minutes.
The indicator
comes on in the display.
The display shows the set drying value
time. for example: . After some
seconds the display shows the final time
value
, that is the total duration of
the washing and drying cycles (washing +
drying + anti-crease + cooling phases).
If you set only 10 minutes of
drying after washing, the
appliance calculates also the
duration of the anti-crease
and the cooling phases.
2. Press Départ/Pause to start the
programme.
In the display the indicator
comes
on. The door is locked. The display
shows regularly a new time value.
ENGLISH
21