EN User Manual Washing Machine L 76685 FL2
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 5 4. CONTROL PANEL...........................................................................................................6 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth.
ENGLISH 2.3 Water connection • Make sure not to cause damage to the water hoses. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.4 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household only. • Obey the safety instructions on the detergent packaging.
www.aeg.com 3.2 How to activate the child safety device wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws, the wood panel must extend beyond the front feet. This device prevents children or pets to be closed in the drum. If possible install the appliance in one of the corners of the room, where the floor is more stable. Turn the device clockwise, until the groove is horizontal. You cannot close the door. 3.
ENGLISH 7 Extra rinse button (Extra Rinse) 10 Temperature button (Temperature) 8 Stain button (Stains) 9 Spin reduction button (Spin) 4.2 Display A B C D Temperature area: Temperature indicator A Cold water indicator. Spin area: Spin speed indicator B No Spin indicator1) Rinse Hold indicator 1) Only available for Spin/Drain programme. Display indicators: Washing phase Rinses phase Spin phase C Child safety lock Door locked You cannot open the appliance door when the symbol is on.
www.aeg.com Time area: Programme duration Delay start D Alarm codes Message of error Programme is completed 5. PROGRAMMES 5.1 Programme Chart Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) Washing programmes Cottons 95°C - Cold 8 kg 1600 rpm White cotton and coloured cotton. Normal soil and light soil. Cottons + Prewash 95°C - Cold 8 kg 1600 rpm White cotton and coloured cotton. Heavy soil and normal soil.
ENGLISH Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) Rinse 8 kg 1600 rpm To rinse and spin the laundry. All fabrics. Jeans 60°C - Cold 8 kg 1200 rpm Items in denim and jersey. Also for dark coloured items. 20 Min. - 3 Kg 40°C - 30°C 3 kg 1200 rpm Cottons and synthetics items with light soil level or worn only once. Super Eco Cold 3 kg 1200 rpm Mixed fabric (cotton and synthetic items)4).
www.aeg.com Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) Anticrease 40°C 1.5 kg Steam programme for cotton and synthetic items. This cycle helps to dewrinkle the laundry. 1) To reduce the creases of the laundry, this cycle regulates the water temperature and performs a soft wash and spin phase. The appliance adds some rinses. 2) During this cycle the drum rotates slowly to ensure a gentle washing.
ENGLISH Programme Spin Stains Jeans ■ 20 Min. - 3 Kg ■ Super Eco ■ ■ ■ ■ Cottons Eco ■ Extra Rinse Time Save 11 Delay Start ■ ■ ■ ■ ■ ■ ■ ■ ■ 1) Set the spin speed. Make sure it agrees with the laundry. If you set No Spin option the only drain phase is available. 5.2 Woolmark Apparel Care Blue Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine.
www.aeg.com Programmes Load (kg) Energy con- Water consumption sumption (kWh) (litre) ApproxiRemaining mate promoisture gramme du- (%)1) ration (minutes) Cottons 60 °C 8 1.60 72 168 44 Cottons 40 °C 8 1.00 72 164 44 Synthetics 40 °C 4 0.60 50 110 35 Delicates 40 °C 4 0.70 60 91 35 1.5 0.35 57 58 30 Wool/Silk 30 °C 2) Standard cotton programmes Standard 60 °C cotton 8 0.83 52 208 44 Standard 60 °C cotton 4 0.63 39 161 44 Standard 40 °C cotton 4 0.
ENGLISH 7.3 Permanent Extra Rinse With this option you can permanently have an extra rinse when you set a new programme. 13 • To activate/deactivate this option press Delay Start and Time Save at the same time until the indicator Extra Rinse comes on/goes off. 8. OPTIONS 8.1 Programme knob When you set this function, put the stain Turn this knob to set a programme. The related programme indicator comes on. remover into compartment 8.
www.aeg.com 9. BEFORE FIRST USE 1. Put 2 litre of water in the detergent compartment for washing phase. This activates the drain system. 2. Put a small quantity of detergent in the compartment for washing phase. 3. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. 10. DAILY USE 10.1 Activating the appliance 1. Open the water tap. 2. Connect the mains plug to the mains socket. 3.
ENGLISH 1 2 3. To use powder detergent, turn the flap up. A 15 With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit showed in the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 10.5 Setting a programme 4.
www.aeg.com The drain pump can operate for a short time when the appliance fills water. 10.7 Behaviour of the appliance After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the cycle time to the laundry you have put in the drum to have perfect washing results in the minimum necessary time. • The display shows the new time value. 10.8 Starting a programme with the delay start 1.
ENGLISH 10.13 End of cycle When the programme has finished, the appliance stops automatically. The acoustic signal operates (if it is active). In the display comes on and the door locked indicator goes off. The indicator of Start/Pause button goes off. 1. Press button On/Off to deactivate the appliance. After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance.
www.aeg.com • Turn inside out multilayered fabrics, wool and items with painted illustrations. • Remove hard stains. • Wash with a special detergent heavy soil stains. • Be careful with the curtains. Remove the hooks or put the curtains in a washing bag or pillowcase. • Do not wash in the appliance laundry without hems or with cuts. Use a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). • A very small load can cause balance problems with the spin phase.
ENGLISH 12.2 Descaling 19 the drum. Make regularly a maintenance wash. To do this: If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines. • Remove the laundry from the drum. • Set the cotton programme with the highest temperature with a small quantity of detergent. Regularly examine the drum to prevent limescale and rust particles. 12.4 Door seal To remove rust particles use only special products for washing machine.
www.aeg.com 12.6 Cleaning the drain filter Do not clean the drain filter if the water in the appliance is hot. 1. 2. 2 1 1 2 1 3. 4. 1 5. 6.
ENGLISH 7. 8. 1 2 9. 2 1 12.7 Cleaning the inlet hose and the valve filter 1. 2.
www.aeg.com 3. 4. 45° 20° 12.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. When you drain the water with the emergency drain procedure, you must activate again the drain system: Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH • - No communication between electronic elements of the appliance. Switch off and switch on again. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre. 23 WARNING! Deactivate the appliance before you do the checks. 13.2 Possible failures Problem Possible solution The programme does not start. Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed.
www.aeg.com Problem Possible solution Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor.
ENGLISH Problem 25 Possible solution Decrease the laundry load. You cannot set an option. Make sure that you press only the wanted button(s). After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. 14.
www.aeg.
ENGLISH 27
132900640-A-202015 www.aeg.