User manual

31ENGLISH
DAILY USE
Now, you can set a new washing pro-
gramme.
INFORMATION
Before starting the new programme
the appliance could drain the water.
In this case, make sure that the
detergent is still in the detergent
compartment, if not fi ll the detergent
again.
12.12 Opening the door
INFORMATION
If the temperature and level of the
water in the drum are too high and/
or the drum still rotates you cannot
open the door.
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Start/Pause.
In the display the related door lock
indicator goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pause.
The programme or the delay start
continues.
12.13 End of cycle
When the programme has fi nished,
the appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
comes on and the door
locked indicator goes off.
The indicator of Start/Pause button
goes off.
1. Press button Ein/Aus to deactivate
the appliance.
After fi ve minutes from the end of the
programme, the energy saving func-
tion automatically deactivates the
appliance.
INFORMATION
When you activate the appliance
again, the display show the end of
the last set programme. Turn the
programme knob to set a new cycle.
2. Remove the laundry from the appli-
ance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mil-
dew and odours
12.14 Draining water out after
end of cycle
The washing programme is com-
pleted, but there is water in the
drum:
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator
is on. The
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pause button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
goes
off, you can open the door.
4. Press Ein/Aus some seconds to
deactivate the appliance.