User manual

37ENGLISH
CARE AND CLEANING
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1. When you drain the water with
the emergency drain procedure,
you must activate again the drain
system:
Put 2 litres of water in the main
wash compartment of the detergent
dispenser.
2. Start the programme to drain the
water
13.9 Frost precautions
If the appliance is installed in an area
where the temperature can be less
than 0° C, remove the remaining
water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the end of the inlet hose
in a container and let the water fl ow
out of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the temperature is
more than 0°C before you use the
appliance again.
The manufacturer is not responsible
for damages caused by low tem-
peratures.