User manual

38 www.aeg.com
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1 Introduction
If the appliance does not start or it
stops during the cycle, fi rst check in
the below table the cause and the pos-
sible solution.
WARNING!
Deactivate the appliance before you
do the checks.
In case of some faults, the acous-
tic signals operate and the display
shows an alarm code:
•
- The appliance does not load
water properly:
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly. Please check
the door!
•
- The mains supply is unstable.
Wait until the mains supply is
stable.
•
- No communication between
electronic elements of the appli-
ance. Switch the appliance off and
on again.
•
- The anti-fl ood device is on:
a. Close the water tap.
b. Disconnect the appliance.
c. Contact the Authorised Service
Centre.
14.2 Possible failures
Problem Possible solution
The programme does not
start.
Make sure that the mains plug is connected to the
mains socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the
fuse box.
Make sure that the Start/Pause has been
pressed.
If the delay start is set, cancel the setting or wait
for the end of countdown.
Deactivate the Child Lock option if it is on.
Refer to “Child lock” , in “Settings” chapter.