User manual

8 www.aeg.com
2. SAFETY INSTRUCTIONS
2.1 Installation
• Remove all the packaging and the
transit bolts.
• Keep the transit bolts. When you
move the appliance again you must
block the drum.
• Always be careful when you move
the appliance because it is heavy.
Always wear safety gloves.
• Do not install or use a damaged
appliance.
• Obey the installation instruction sup-
plied with the appliance.
• Do not install or use the appliance
where the temperature is less than
0°C or where it is exposed to the
weather.
• Make sure that the fl oor where you
install the appliance is fl at, stable,
heat resistant and clean.
• Make sure that there is air circula-
tion between the appliance and the
fl oor.
• Adjust the feet to have the neces-
sary space between the appliance
and the carpet.
• Do not install the appliance where
the appliance door can not be fully
opened.
2.2 Electrical connection
• The appliance must be earthed.
• Always use a correctly installed
shockproof socket.
• Make sure that the electrical infor-
mation on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the mains plug and to the mains ca-
ble. Should the mains cable need to
be replaced, this must be carried out
by our Authorised Service Centre.
• Connect the mains plug to the
mains socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• Do not touch the mains cable or the
mains plug with wet hands.
• Do not pull the mains cable to dis-
connect the appliance. Always pull
the mains plug.
• Only for UK and Ireland: The appli-
ance has a 13 amp mains plug. If it
is necessary to change the fuse in
the mains plug, use a 13 amp ASTA
(BS 1362) fuse.
• This appliance complies with the
E.E.C. Directives.
2.3 Water connection
• Connect the appliance to mains
water supply in accordance with
current local and national safety
regulation.
• This appliance was thought to be
connected only to cold water supply.
• For any reason, do not disconnect
the Ultra Anti-fl ood inlet hose from
the appliance. If it is necessary, con-
tact the Authorised Service Centre.
• The Ultra Anti-fl ood inlet hose
contains electrical components. If
the inlet hose in not connected to
the tap water, disconnect the mains