User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. PROGRAMMES
- 6. CONSUMPTION VALUES
- 7. OPTIONS
- 8. SETTINGS
- 9. BEFORE FIRST USE
- 10. DAILY USE
- 10.1 Loading the laundry
- 10.2 Filling the detergent and additives
- 10.3 Check the position of the flap
- 10.4 Activating the appliance
- 10.5 Setting a programme
- 10.6 Starting a programme without the delay start
- 10.7 Behaviour of the appliance
- 10.8 Starting a programme with the delay start
- 10.9 Cancelling the delay start
- 10.10 Interrupting a programme and changing a function
- 10.11 Cancelling a running programme
- 10.12 Opening the door
- 10.13 End of cycle
- 10.14 Draining water out after end of cycle
- 10.15 AUTO Stand-by option
- 11. DAILY USE - DRYING ONLY
- 12. DAILY USE - WASHING & DRYING
- 13. HINTS AND TIPS
- 14. CARE AND CLEANING
- 15. TROUBLESHOOTING
- 16. TECHNICAL DATA
A
4. To use liquid detergent, turn the flap
down.
B
With the flap in the
position DOWN:
• Do not use
gelatinous or thick
liquid detergents.
• Do not put more
liquid detergent than
the limit showed in
the flap.
• Do not set the
prewash phase.
• Do not set the delay
start function.
5. Measure out the detergent and the
fabric conditioner.
6. Carefully close the detergent
dispenser.
Make sure that the flap does not cause a
blockage when you close the drawer.
10.4 Activating the appliance
1. Open the water tap.
2. Connect the mains plug to the mains
socket.
3. Press button On/Off to activate the
appliance.
A short tune sounds.
10.5 Setting a programme
1. Turn the programme knob and set
the programme:
• The related programme indicator
comes on.
• The indicator of Start/Pause
flashes.
• The display shows: the default
temperature, the spin speed, the
indicators of the programme
phases and the programme
duration.
2. If necessary, change the
temperature, the spin speed, the
cycle duration, or add available
options. When you activate an
option, the indicator of the set
option comes on.
If you set something
incorrect, the display shows
the message Err.
10.6 Starting a programme
without the delay start
Press button Start/Pause to start the
programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase
is operation starts to flash.
The programme starts, the door is
locked. The display show the indicator
.
The drain pump can operate
for a short time when the
appliance fills water.
www.aeg.com18