L7FEE1612N USER MANUAL EN User Manual Washing Machine
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 3 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION............................................................................................................6 4. PRODUCT DESCRIPTION.........................................................................................10 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com by clients in hotels, motels, bed & breakfast and other residential type environments; – areas for communal use in blocks of flats or in launderettes. Do not exceed the maximum load of 10 kg (refer to the "Programme chart" chapter). The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering.
ENGLISH • The floor area on which the appliance is to be installed must be flat, stable, heat resistant and clean. • Make sure that there is air circulation between the appliance and the floor. • When the appliance is in its permanent position, check if it is levelled correctly with the aid of a spirit level. If it is not, adjust the feet accordingly. • Do not install the appliance directly above a floor drain. • Do not spray water on the appliance and do not expose it to excessive humidity.
www.aeg.com 2.6 Disposal WARNING! Risk of injury or suffocation. • Disconnect the appliance from the mains electrical and water supplies. • Cut off the mains electrical cable close to the appliance and dispose of it. • Remove the door catch to prevent children or pets from becoming trapped in the drum. • Dispose of the appliance in accordance with local requirements for the disposal of Waste Electrical and Electronic Equipment (WEEE). 3. INSTALLATION WARNING! Refer to Safety chapters. 3.
ENGLISH 7. Remove the polystyrene protection from the bottom. 10. Remove the three bolts by using the spanner supplied with the appliance. 1 2 8. Pull up the appliance in vertical position. 9. Remove the power supply cable and the drain hose from the hose holders. It is possible to see water flowing from the drain hose. This is due to the testing with water of the appliance in factory. 7 11. Pull out the plastic spacers. 12. Put the plastic caps, that you find in the user manual bag, in the holes.
www.aeg.com WARNING! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level. 2. Position it toward left or right depending on the position of the water tap. 45 20 x4 The appliance must be level and stable. A correct adjustment of the appliance level prevents the vibration, noise and the movement of the appliance when in operation.
ENGLISH 9 A If this occurs, close the water tap and contact the authorized service centre to replace the hose. 3.5 Water drainage The drain hose should stay at a height of not less than 60 cm and not more than 100 cm. You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. Make sure that the drain hose end is not immersed in the water. There may be a return of dirty water into the appliance. 3.
www.aeg.com 5. Without the plastic hose guide, to a sink spigot - Put the drain hose in the spigot and tighten it with a clamp. Refer to the illustration. 6. Position the hose directly to a builtin drain pipe in the room wall and tighten it with a clamp. Make sure that the drain hose makes a loop to prevent particles going into the appliance from the sink. 4. PRODUCT DESCRIPTION 4.
ENGLISH 11 4.2 Appliance overview 1 2 8 3 9 10 4 5 11 12 6 7 1 2 3 4 5 6 7 Worktop Detergent dispenser Control panel Door handle Rating plate Drain pump filter Feet for levelling the appliance 8 9 10 11 12 Drain hose Inlet hose connection Mains cable Transit bolts Hose support 5. CONTROL PANEL 5.
www.aeg.
ENGLISH 13 Rinsing phase indicator. It flashes during rinse phase. When the Soft Plus option is activated, the indicator appears. Spinning and draining phase indicator. It flashes during spin and drain phase. Steam phase indicator. Anti-crease phase indicator. Child safety lock indicator. Energy saving indicators. The indicator appears by selecting a programme for cotton at 40 °C or 60 °C. Time saving indicator. Spin speed indicator. Rinse hold indicator. Extra Silent indicator. Temperature indicator.
www.aeg.com Touch this button repeatedly until the desired temperature value appears on the display. When the display shows the indicators and , the appliance does not heat the water. 6.4 脱水 When you set a programme, the appliance automatically sets the maximum spin speed allowed. Touch repeatedly this button to: • Decrease the spin speed. The display shows only the spin speeds available for the set programme. • Activate the Rinse Hold option. The final spin is not performed.
ENGLISH This option is recommended for heavily soiled laundry, especially if containing sand, dust , mud and other solid particles. The options can increase the programme duration. 6.6 易熨烫 This option adds a steam phase followed by a short anti-crease phase at the end of the washing programme. The steam phase reduces fabric creasing and facilitates the fabric ironing. The indicator flashes on the display during steam phase. This option can increase the programme duration.
www.aeg.com If you select the Cotton programme at 40°C or 60°C and no other options are set, the display shows the ; these are indicator the standard cotton programmes, the most efficient programmes in terms of combined energy and water consumption. 6.11 启动/暂停 Touch the 启动/暂停 button to start, pause the appliance or interrupt a running programme. 7. PROGRAMMES 7.1 Programme Chart Washing programmes Programme Programme description Washing programmes 棉织物 White cotton and coloured cotton.
ENGLISH Programme 抗过敏 17 Programme description White cotton items. This programme removes micro-organisms thanks to a washing phase with the temperature maintained above 60°C for several minutes. This helps remove germs, bacteria, micro-organism and particles. An additional rinsing phase ensures a proper removal of detergent residues and pollens/allergenic items. In this way the wash is more effective. Cotton and synthetic items lightly soiled or once worn.
www.aeg.com Programme temperature, maximum spin speed and maximum load Programme Default tempera- Maximum spin speed Maximum load ture Spin speed range Temperature range Washing programmes 棉织物 40 °C 95 °C - Cold 1600 rpm 1600 rpm - 400 rpm 10 kg 化纤 40 °C 60 °C - Cold 1200 rpm 1200 rpm - 400 rpm 4 kg 精细 40 °C 40 °C - Cold 1200 rpm 1200 rpm - 400 rpm 4 kg 羊毛/手洗 40 °C 40 °C - Cold 1200 rpm 1200 rpm - 400 rpm 1.5 kg Steam programme - 蒸汽 - 1.
ENGLISH 19 7.2 Woolmark Apparel Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine. Follow the garment care label for drying and other laundry instructions. M1230 The Woolmark symbol is a Certification mark in many countries. 8. SETTINGS 8.
www.aeg.com This option increases slightly the programme duration. To activate/deactivate this option touch the 温度 button and the 脱水 button simultaneously until the indicator comes on/goes off above the indicator. 9. BEFORE FIRST USE 1. Make sure that all transit bolts have been removed from the appliance. 2. Make sure that the electrical power is available and the water tap is open. 3. Pour 2 litres of water into the detergent compartment marked by 5.
ENGLISH 10.3 Filling the detergent and additives 21 1 2 3. To use powder detergent, turn the flap up. Compartment for prewash phase an soak programme. Compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Maximum level for quantity of liquid additives. Compartment for stain remover. Flap for powder or liquid detergent.
www.aeg.com With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. In case a selection is not possible, no indicator comes on and an acoustic signal sounds. 10.6 Starting a programme Touch the 启动/暂停 button to start the programme.
ENGLISH Changing the delay start after the countdown has started this case, it will be not possible to guarantee the best washing results. To change the delay start: 1. Touch the 启动/暂停 button to pause the appliance. The related indicator flashes. 2. Touch the 预约 button repeatedly until the display shows the desired delay time. 3. Touch the 启动/暂停 button again to start the new countdown. 10.8 The ProSense load detection The programme duration in the display is referred to a medium/high load.
www.aeg.com The washing programme continues. 10.13 End of the programme 10.11 Cancelling a running programme When the programme has finished, the appliance stops automatically. The acoustic signals operate (if they are active). 1. Press the button 开/关 to cancel the programme and to deactivate the appliance. 2. Press the button 开/关 again to activate the appliance. Now, you can set a new washing programme.
ENGLISH 1. If necessary, touch the 脱水 button to decrease the spin speed proposed by the appliance. 2. Touch the 启动/暂停 button: • If you have set , the appliance drains the water and spins. • If you have set , the appliance only drains the water. The option indicator or goes out, while the indicator flashes and then goes off. 3. When the programme is completed and the door locked indicator goes off, you can open the door. 4. Press the 开/关 button a few seconds to deactivate the appliance.
www.aeg.com 11.2 Stubborn stains • Use the recommended detergents for the type and colour of the fabric, the programme temperature and the level of soil. For some stains, water and detergent is not sufficient. We recommend that you pre-treat these stains before you put the items in the appliance. Special stain removers are available. Use the special stain remover that is applicable to the type of stain and fabric. 11.
ENGLISH The regular detergents already contain water softening agents, but we recommend to run a cycle with empty drum and a descaling product occasionally. Always follow the instructions that you find on the packaging of the product. 12.3 Maintenance wash The repeated and prolonged use of low temperature programmes can cause detergent deposits, fluff residues, bacterial growth inside the drum and the tub. This could generate bad odours and mildew.
www.aeg.com WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to clean the pump: 4. Insert the detergent drawer into the guide rails and close it. Run the rinsing programme without any clothes in the drum. 1. Open the pump cover. 2 1 12.7 Cleaning the drain pump WARNING! Disconnect the mains plug from the mains socket. 2.
ENGLISH 5. When the bowl is full of water, turn the filter back and empty the container. 6. Repeat the steps 4 and 5 until the water stops to flow out. 7. Turn the filter anti-clockwise to remove it. 29 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 2 1 12. Close the pump cover. 1 2 8. If it is necessary, remove fluff and objects from the filter recess. 9.
www.aeg.com 12.8 Cleaning the inlet hose and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1. Remove the inlet hose from the tap and clean the filter. 45° 20° 1 12.9 Emergency drain 2 3 2. Remove the inlet hose from the appliance by loosening the ring nut. If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph.
ENGLISH 31 13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. In case of major problems, the acoustic signals operate, the display shows an alarm code and the 启动/暂停 button may flash continuously: • - The appliance does not fill with water properly.
www.aeg.com Problem The appliance does not fill with water properly. Possible solution • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. • Make sure that the inlet hose has no kinks, damages or bends. • Make sure that the connection of the water inlet hose is correct.
ENGLISH 33 Problem Possible solution The appliance makes an unusual noise and vibrates. • Make sure the levelling of the appliance is correct. Refer to "Installation instruction". • Make sure that the packaging and/or the transit bolts are removed. Refer to "Installation instruction". • Add more laundry in the drum. The load may be too small. The programme duration • The ProSense function is able to adjust the programme duincreases or decreases ration according to the type and the laundry load size.
www.aeg.com 2. Disconnect the mains plug from the mains socket. 3. Open the filter flap. 4. Pull twice the emergency unlock trigger downward and open the appliance door. 5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 14.
ENGLISH 35 15. ACCESSORIES 15.1 Available in www.aeg.com/shop or from authorised dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. Verify the compatible stacking kit by checking the depth of your appliances. The stacking kit can be used only with the appliances specified in the leaflet provided with the accessory. Read carefully the instructions supplied with the appliance and with the accessory.
* X X X X X Motor (including belt) Hydraulics (inlet and drain hoses, pressure switch, pumps, including electrovalves) Control panel (including sensors, electronic boards - user interface, main board, motor control bard) Door (including hinge) Wirings and power cord Hg Cd Cr6+ Hazardous substances PBBs PBDEs 1. This table is compiled according to SJ/T11364-2014. means this kind of hazard substance content in all the homogenous material of this part is under the limitation regulated 2.
ENGLISH 37
www.aeg.
ENGLISH 39
157015401-A-252018 www.aeg.