Operation Manual

By doing this, any water remaining in the machine is removed, avoiding ice forming and
consequently damage to the appliance.
When you use the machine again, make sure that the ambient temperature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has cooled down;
4. open the pump door;
5. place a bowl on the floor and place the end of the emergency emptying hose into the
bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl
is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water
stops flowing out;
6. clean the pump if necessary as previously described;
7. replace the emergency emptying hose in its seat after having plugged it;
8. screw the pump again and close the door.
What to do if…
Certain problems are due to lack of simple maintenance or oversights, which can be solved
easily without calling out an engineer. Before contacting your local Service Centre, please
carry out the checks listed below.
During machine operation it is possible that the yellow pilot light of button 7 blinks, one
of the following messages appear on the display and at the same time some acoustic signals
sound every 20 seconds to indicate that the machine is not working:
•
Problem with the water supply: «Cannot fill water. Please check that the tap is open
and then press START/PAUSE».
•
Problem with the water draining: «Cannot drain the water. Please check that the
filter is clean and then press START/PAUSE».
•
Door open: «Please check that the door is closed properly and then press START/PAUSE».
•
Anti-flooding system has activated: «Anti-flooding system has been activated. Please
check inlet/drain pipe connections».
Once the problem has been eliminated, press the button 7 to restart the programme. If
after all checks, the problem persists, contact your local Service Centre.
28
What to do if…