Operation Manual

an animated bar, that indicates the carried out cycle and the remaining one, the duration
of the washing program and the end of cycle.
Delay start
If you have selected the button 8 , the relevant symbol 9.5 appears on the display.
After having pressed the button 7 , the selected delay time value (max 20 hours) appears
on the right side of the display with the corrisponding symbol.
The delay time value decreases every minute ( 9.8 ).
Incorrect option selection
If a wrong option is selected the display says that it is not selectable.
Alarm codes
In the event of operating problems, some alarm messages can be displayed, for example:
«Cannot fill water. Please check that the tap is open and then press STAR/PAUSE» (see
chapter «What to do if...»).
End of the programme
When the programme has finished the corresponding message appears on the display. The
button 7 pilot light goes off.
If your laundry is not removed during 10 minutes after the programme is finished, the
backlight of the display switches off and the energy saving system will be enabled.
Only the button 7 pilot light is blinking to indicate that the appliance has to be switched
off.
By pressing any button the appliance will come out from the energy saving status and you
could set another washing programme or swich the appliance off.
First use
• Ensure that the electrical and water connections comply with the installation instruc-
tions.
• Remove the polystyrene block and any material from the drum.
• Before the first wash, run a cotton cycle at the highest temperature without any laundry
in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2
a measure of detergent into the main wash compartment and start the machine.
Setting the language
When switching on the appliance for the first time, by turning the programme selector dial
1 , you must set the language that you prefer. When the appliance is switched on again all
the messagges in the display will appear in this language.
If the display is not showing any language screen, the appliance has already been switched
on once. In such case, if you would change the language setting, press at the same time
the buttons 2 and 3 for 6 seconds to activate the menu language.
By pressing the button 4 you can scroll all the available languages.
First use
9