L 87404 FL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 8 9 10 4 5 11 6 12 7 1 Worktop 2 Detergent dispenser 3 Control panel clockwise, until the groove is horizontal. To deactivate the device, turn it counterclockwise, until the groove is vertical. 4 Door handle 5 Rating plate 6 Drain pump 7 Feet for the appliance level 8 Water drain hose 9 Water inlet valve 10 Mains cable 11 Transit bolts 12 Feet for the appliance level 3.1 Child safety device • When you activate this device, you cannot close the door.
ENGLISH 7 4. CONTROL PANEL 1 2 Katoen Ontkreuk Opfrissen Katoen Eco Super Eco Extra Stil Synthetica Strijkvrij 20 Min. - 3kg Fijne Was Jeans Spoelen Centrifugeren/ Pompen 3 Wol/Zijde Dekbed Anti-Allergie Auto Off Temp.°C 10 1 On/Off button (Auto Off) TPM 9 Tijd Vlekken/ Extra Voorwas Spoelen Besparen 8 7 6 Startuitstel 5 Start/Pauze 4 10 Temperature button (Temp.
www.aeg.com 4.3 Display 3 A B C D L E F K G J H I The display shows: The temperature of the set programme A Cold water The spin speed of the set programme B No Spin symbol1) Rinse Hold symbol 1) Only available for Spin/Drain programme. Prewash phase Washing phase Rinses phase Spin phase C The phase symbols • When a programme is set, all the symbols of the phases related to the programme come on. • When the programme starts, only the symbol of the phase in operation flashes.
ENGLISH 9 You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off. If the programme is completed but the symbol stays on: • The 'Rinse Hold' function is on. • There is water in the drum. F The delay start symbol comes on when you set the delay start function. G • The programme time When the programme starts, the programme time decreases with steps of 1 minute.
www.aeg.com The indicator bar is fully filled when you set to the maximum number of rinses. The Stain symbol comes on when you activate the function. The Prewash symbol comes on when you activate the function. L The indicator bar is not fully filled when you set only one of the functions. The indicator bar is fully filled when you set the two functions. 4.4 Start/Pause button 4 Press button 4 to start or interrupt a programme. 4.
ENGLISH • You activate the appliance. • You deactivate the appliance. • You press the buttons. • The programme is completed. • The appliance has a malfunction. To deactivate/activate the acoustic signals, press button 8 and button 7 at the same time for 6 seconds. If you deactivate the acoustic signals, they continue operate only when you press the buttons and when a malfunction occurs. 4.12 Child lock function This function prevents children to play with the control panel.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Dekbed 60°C - 30°C Special programme for one synthetic blanket, duvet, bedspread and so on. 3 kg, 800 rpm Anti-Allergie 60°C White cotton items. This programme removes micro-organisms thanks to the washing by 60° C and adds one rinse. In this way the wash is more effective. 10 kg, 1400 rpm Centrifugeren/Pompen2) To spin the laundry and to drain the water in the drum. All fabrics.
ENGLISH 13 ■ Synthetica ■ ■ Strijkvrij ■ ■ Fijne Was ■ ■ Wol/Zijde ■ ■ Dekbed ■ Anti-Allergie ■ Centrifugeren/ Pompen1) ■ Spoelen ■ ■ Jeans ■ ■ 20 Min.
www.aeg.com 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can greatly be reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 10 kg, the programme duration exceeds 2 hours; real load 1 kg, the programme duration don’t reach 1 hour).
ENGLISH 2. Put a small quantity of detergent in the main wash compartment of the detergent dispenser. Set and start a programme for cotton at the highest 15 temperature without laundry. This removes all possible dirt from the drum and the tub. 8. USING THE APPLIANCE 1. 2. 3. Open the water tap. Connect the mains plug to the mains socket. Press button 1 to activate the appliance. 4. Put the laundry in the appliance. 5. Use the correct quantity of detergent and additives. 6.
www.aeg.com The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme. Liquid additives compartment (fabric conditioner, starch). Put the product in the compartment before you start the programme. This is the maximum level for the quantity of liquid additives. The compartment for the stain remover. Put the product in the compartment and set the stain function before you start the programme.
ENGLISH 4. 17 To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid detergent than the limit showed in the flap. – Do not set the prewash phase. – Do not set the delay start function. 5. 6. Measure out the detergent and the fabric conditioner. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 8.3 Set the delay start 1.
www.aeg.com 2. Press button 4 again. The washing programme continues. 8.7 Cancel a programme 1. Press button 1 to cancel the programme and to deactivate the appliance. 2. Press button 1 again to activate the appliance. Now, you can set a new washing programme. The appliance does not drain the water. 8.8 Change a function You can change only some functions before they operate. 1. Press button 4 . The indicator flashes. 2. Change the function set. 8.
ENGLISH 19 9. HINTS AND TIPS 9.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items.
www.aeg.com 10.1 Descaling 10.3 Maintenance wash The water we use contains limescale. If it becomes necessary, use a water softener to remove limescales. Use a special product made for washing machines. Obey the instructions that you find on the packaging of the manufacturer. Do this separately from the laundry wash. With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: • Empty the laundry from the drum.
ENGLISH 3. 4. 5. 6. 10.7 Drain pump Regularly examine the drain pump and make sure that it is clean. 21 Remove the top part of the liquid additive compartment. Clean all the parts with water. Clean the dispenser recess with a brush. Put back the dispenser in the recess. • The display shows an alarm code because of the problem with water drain. WARNING! 1. Disconnect the mains plug from the mains socket. 2. Do not remove the filter while the appliance operates.
www.aeg.com 3. 4. 5. 1 6. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull forward the drainage duct to let the water flow out. When the container is full of water, put the drainage duct back again and empty the container. Do steps 4 and 5 again and again until no more water flows out from the drain pump. Pull back the drainage duct and turn the filter to remove it. 2 2 1 10.
ENGLISH 23 To clean the water inlet filters: Close the water tap. Remove the water inlet hose from the water tap. 3. Clean the filter in the inlet hose with a stiff brush. 1. 2. 4. 5. 6. 7. 20° Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap. 45° 10.9 Emergency drain Because of a malfunction, the appliance cannot drain the water.
www.aeg.com 11. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water properly. • - The appliance does not drain the water. • - The appliance door is open or not closed correctly. • - The anti-flood device is on.
ENGLISH Problem Possible cause Possible solution The appliance door is open or not closed correctly. Close the door correctly. The anti-flood device is on. • Disconnect the appliance. • Close the water tap. • Contact the service centre. The spin phase does not operate. The programme does not start. There is water on the floor. 25 The spin phase is off. Set the spin programme. The filter of the drain pump is blocked. Clean the filter of the drain pump. Refer to 'Care and cleaning'.
www.aeg.com Problem The cycle is shorter than the time displayed. Possible cause Possible solution The load is very small. Add more laundry in the drum. The appliance calculates See the ‘Consumption Values’ a new time according to chapter. the laundry load. The cycle is longer An unbalanced laundry than the time dis- load increases the duraplayed. tion time. The washing results are not satisfactory. This is a normal behaviour of the appliance.
ENGLISH 13. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
132910240-A-332013 www.aeg.
