L 87480 FL EN User manual
www.aeg.com/au CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 TECHNICAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS 1.3 Child safety device 1.1 Conditions of use This appliance is intended to be used in household and similar applications such as: • Farm houses. • By clients in serviced apartments, holiday apartments and other residential type environments. Before installation and use, read this manual carefully: • For your safety and the safety of your property • To help the environment • For the correct operation of the appliance.
www.aeg.com/au 1.6 Installation • The appliance is heavy, be careful when you move it. • Do not transport your appliance without the transit bolts, you can damage internal components and cause leakages or malfunctions. • Do not install and connect a damaged appliance. • Make sure to remove all packaging and transit bolts before first use. • Make sure that the mains plug is disconnected from the mains socket during installation.
ENGLISH Electrical connection: Voltage Overall power Frequency 230-240 V 2200 W 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure 5 IPX4 Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Cold water Water supply 1) Maximum load Cotton Spin speed Maximum 8 kg 1400 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 3.
www.aeg.com/au 3.1 Accessories 1 1 Spanner 2 To remove the transit bolts. 2 Plastic caps 4 To close the holes on the rear side of the cabinet after the removal of the transit bolts. 3 Anti-flood inlet hose To prevent possible leakage 4 Plastic hose guide To connect the drain hose on the edge of a sink. 3 4. CONTROL PANEL 1 2 Anticrease 3 Cottons Refresh Extra Silent Economy Synthetics Super Eco Easy Iron 20 Min.
ENGLISH • After 5 minutes from the end of the washing programme. Refer to 'At the end of programme'. 4.2 Programme knob 2 Turn this knob to set a programme. The related programme indicator comes on. 4.3 Display 3 A B C D L E F K G J H I The display shows: The temperature of the set programme A Cold water The spin speed of the set programme B No Spin symbol1) Rinse Hold symbol 1) Only available for Spin/Drain programme.
www.aeg.com/au The detergent overdosing comes on at the end of the cycle when the appliance detects too much detergent. E You cannot open the door when this symbol is on. You can open the door only when the symbol goes off. If the programme is completed but the symbol stays on: • The 'Rinse Hold' function is on. • There is water in the drum. F The delay start symbol comes on when you set the delay start function.
ENGLISH 9 The value shows the total number of the rinses. The indicator bar is fully filled when you set to the maximum number of rinses. The Stain symbol comes on when you activate the function. The Prewash symbol comes on when you activate the function. L The indicator bar is not fully filled when you set only one of the functions. The indicator bar is fully filled when you set the two functions. 4.4 Start/Pause button 4 Press button 4 to start or interrupt a programme. 4.
www.aeg.com/au - -, the appliance does not heat the water. 4.11 Acoustic signals function You can hear the acoustic signals when: • You turn the appliance on. • You turn the appliance off. • You press the buttons. • The programme is complete • The appliance has a malfunction. To deactivate/activate the acoustic signals, press button 8 and button 7 at the same time for 6 seconds.
ENGLISH Programme Temperature Type of load Max. weight of load Cycle description Functions Synthetics 60° - Cold Synthetic or mixed fabric items with normal soil. max. load 4 kg Wash Rinses Short spin SPIN REDUCTION RINSE HOLD PREWASH1) STAINS2) EXTRA RINSE TIME SAVE3) Easy Iron4) 60 - 0° Synthetic fabrics with normal soil. max.
www.aeg.com/au Programme Temperature Type of load Max. weight of load Cycle description Functions Spin / Drain 5) 0° All fabrics. Drainage of The maximum load of the water the laundry is related to Spin phase. the type of laundry. SPIN REDUCTION NO SPIN Rinse 0° All fabrics. max. load 8 kg One rinse with additive Spin phase SPIN REDUCTION RINSE HOLD EXTRA RINSE6) Jeans 60° - 0° All items in denim. max.
ENGLISH 13 STEAM PROGRAMMES Programme1) Steam – Refresh This cycle removes odours from the laundry. Type of load Max load Cotton and synthetic items up to 1.5 Kg Cotton and synthetic items up to 1.5 Kg Steam does not remove animal odours. Steam – Anticrease This cycle helps to dewrinkle the laundry. Steam can be used for dry, washed or laundry worn once. These programmes can reduce creases and odours and make your laundry more soft. Do not use any detergent.
www.aeg.com/au 7. USING THE APPLIANCE 1. 2. Open the water tap. Connect the mains plug to the mains socket. 3. Press button 1 to activate the appliance. 4. Put the laundry in the appliance. 5. Use the correct quantity of detergent and additives. 6. Set and start the correct programme for the type of laundry and soil. 7.1 Loading the laundry 1. 2. Open the appliance door. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance.
ENGLISH 15 This is the maximum level for the quantity of liquid additives. The compartment for the stain remover. Put the product in the compartment and set the stain function before you start the programme. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liquid detergent. Always obey the instructions that you find on the packaging of the detergent products. Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2.
www.aeg.com/au 5. 6. Measure out the detergent and the fabric conditioner. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 7.3 Setting and starting a programme 1. Turn the programme knob. The related programme indicator comes on. 2. The indicator of button 4 flashes red. 3. The display shows the default temperature, the spin speed and the empty indicator bars of the available functions. 4.
ENGLISH If the temperature and level of the water in the drum are too high, the door lock symbol stays on and you cannot open the door. To open the door do the steps that follow: 1. Deactivate the appliance. 2. Wait for some minutes. 3. Make sure that no water is in the drum. If you deactivate the appliance, it is necessary to set the programme again. 7.10 At the end of programme • The appliance stops automatically. • The acoustic signals operate. • In the display comes on.
www.aeg.com/au • A very small load can cause balance problems with the spin phase. If this occurs, adjust the items in the tub manually and start the spin phase again. 8.2 Stubborn stains For some stains, water and detergent is not sufficient. We recommend that you remove these stains before you put the items in the appliance. Special stain removers are available. Use the special stain remover that is applicable to the type of stain and fabric. 8.
ENGLISH find on the packaging of the manufacturer. Do this as an extra wash cycle without laundry. 9.2 External cleaning Only clean the appliance with warm soapy water. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. 19 the drum. Make sure to do a regular maintenance wash. To do this: • Empty the laundry from the drum. • Set the hottest cotton wash programme • Use a correct quantity of powder detergent with biological properties.
www.aeg.com/au 3. 4. 5. 6. 9.7 Drain pump Regularly examine the drain pump and make sure that it is clean. Remove the top part of the liquid additive compartment. Clean all the parts with water. Clean the dispenser recess with a brush. Put the dispenser back in the recess. • The display shows an alarm code because of the problem with water drain. WARNING! 1. Disconnect the mains plug from the mains socket. 2. Do not remove the filter while the appliance operates.
ENGLISH 3. 4. 5. 1 6. 21 Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull forward the drainage duct to let the water flow out. When the container is full of water, put the drainage duct back again and empty the container. Do steps 4 and 5 repeatedly until no more water flows out from the drain pump. Pull back the drainage duct and turn the filter to remove it. 2 2 1 9.
www.aeg.com/au To clean the water inlet filters: Close the water tap. Remove the water inlet hose from the water tap. 3. Clean the filter in the inlet hose with a stiff brush. 1. 2. 4. 5. 6. 7. 20° Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap. 45° 9.9 Emergency drain Because of a malfunction, the appliance cannot drain the water.
ENGLISH 23 10. TROUBLESHOOTING The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. • - The appliance door is open or not closed correctly. • - The anti-flood device is on.
www.aeg.com/au Problem Possible cause The anti-flood device is on. The spin phase does not operate. The programme does not start. There is water on the floor. Possible solution • Disconnect the appliance. • Close the water tap. • Contact the service centre. The spin phase is off. Set the spin programme. The filter of the drain pump is blocked. Clean the filter of the drain pump. Refer to 'Care and cleaning'. Balance problems with the laundry load.
ENGLISH 25 Problem Possible cause Possible solution The appliance fills with water and drains immediately. The end of the drain hose is too low. Make sure that the drain hose is in the correct position. The washing results are not satisfactory. The detergent you used Increase the detergent quantity was not sufficient or cor- or use a different one. rect. You did not remove stubborn stains before washing. Use special products to remove the stubborn stains. Incorrect temperature was set.
www.aeg.com/au 4. Remove the internal film. 5. Open the door. Remove the polystyrene piece from the door seal and all the items from the drum. 6. Put one of the polystyrene packaging elements on the floor behind the appliance. Carefully lay the appliance down with the rear side on the packaging. Make sure you do not damage the hoses. 7. Remove the polystyrene protection from the bottom. Pull the appliance back into the vertical position. 8.
ENGLISH 9. 27 Remove the power supply cable and the drain hose from the hose holders. 10. Remove the three transit bolts. Use the key supplied with the appliance. 11. Pull out the plastic spacers. 12. Put the plastic caps provided in the user manual bag. WARNING! Remove all the packaging and the transit bolts before you install the appliance. We recommend that you keep the packaging and the transit bolts for when you move the appliance.
www.aeg.com/au 11.2 Positioning and levelling • Install the appliance on a flat hard floor. • Make sure that carpets do not stop the air circulation below the appliance. • Make sure that the appliance does not touch the wall or other units • Loosen or tighten the feet to adjust the level. The correct adjustment of the appliance levelling feet prevents vibration, noise and the movement of the appliance when in operation. x4 • The appliance must be level and stable.
ENGLISH 29 • Connect the water inlet hose to the cold water tap with ¾” thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose. Water-stop device The inlet hose has a water stop device. This device prevents water leaks in the hose because of its natural ageing. The red sector in the window «A» shows this fault .
www.aeg.com/au • On the edge of a sink. • Make sure that the plastic guide cannot move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into a drain pipe at a height of not less than 60 cm and not more than 100 cm. The end of the drain hose must always be ventilated , i.e. the inner diameter of the drainpipe must be larger than the external diameter of the drain hose. Without the plastic hose guide.
ENGLISH 31 12. WARRANTY FOR SALES IN AUSTRALIA AND NEW ZEALAND ALL AEG BRANDED APPLIANCES This document sets out the terms and conditions of the product warranties for AEG Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1.
www.aeg.com/au 6. 7. 8. 9. ance is transported at the owner’s cost and risk while in transit to and from AEG or its ASC. Proof of purchase is required before you can make a claim under this warranty. You may not make a claim under this warranty unless the defect claimed is due to faulty or defective parts or workmanship.
ENGLISH 33 Before calling for service, please ensure that the steps listed in point 13 above have been followed. SERVICE AUSTRALIA www.aeg.com/au FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL customercare@aegaustralia.com.au For the cost of a local call (Australia only) FOR SPARE PARTS or to find the address of your nearest state spare parts centre in Australia PLEASE CALL 13 13 50 OR EMAIL customercare@aegaustralia.com.
www.aeg.
ENGLISH 35
132935722-A-232013 www.aeg.