User manual

The anti-crease symbol comes on.
The drying time symbol comes on.
The display shows the set drying value
time .
Set drying time value.
Each time you press this button the time
value increases by 5 minutes.
To have a good drying we
suggest you to do not set a
too low spin speed for the
items to be washed and
dried.
2. After some seconds the display
shows the total duration of the
cycles:
Final time value (washing + drying
+ anti-crease + cooling phases)
If you set a drying time of
only 10 minutes, the final
time value includes also the
anti-crease and the cooling
phases.
3. Press button Start/Pauze - Départ/
Pause to start the programme.
The door is locked.
The display shows the new time value
each minute.
11.4 At the end of the drying
programme
1. The appliance stops automatically.
2. The acoustic signals operate (if they
are active).
3. In the display
comes on.
4. The indicator of button Start/Pauze -
Départ/Pause goes off.
5. The last minutes of the drying cycle
the appliance performs the anti-
crease phase.
The anti-crease symbol
flashes.
The door is still locked (the symbol
is on).
6. Press button Aan/Uit - Marche/Arrêt
for some seconds to deactivate the
appliance.
After some minutes from
the end of the
programme, the energy
saving function
automatically
deactivates the
appliance.
7. When the door locked light goes
off you can open the door.
8. Remove the laundry from the
appliance. Make sure that the drum
is empty.
9. Keep the door ajar, to prevent
mildew and odours.
10. Close the water tap.
11.5 Fluff in the fabrics
During the washing and/or drying phase,
some types of fabric, (sponge, wool,
sweatshirt) could release fluff.
The released fluff could stick to the
fabrics during the next cycle.
To prevent the fluff in your laundry, we
recommend that you:
• Do not wash dark fabrics after you
have washed and dried light coloured
fabrics (new sponge, wool, sweatshirt )
and the contrary.
• Line dry this type of fabrics at open air
when they are washed the first time.
• Clean the drain filter.
• After the drying phase, clean the
empty drum, the gasket and the door
with a wet cloth.
11.6 How to remove the fluff
in the garments
To remove the fluff inside the drum, set a
special programme:
1. Empty the drum.
2. Clean the drum, the gasket and the
door with a wet cloth.
3. Set the rinse programme.
www.aeg.com
26