Operation Manual

10.4 At the end of the drying
programme
1. The appliance stops automatically.
2. The acoustic signals operate (if they
are active).
3. In the display comes on.
4. The indicator of button Start/Pause
goes off.
5. The last minutes of the drying cycle
the appliance performs the anti-
crease phase.
The anti-crease symbol flashes.
The door is still locked (the symbol
is on).
6. Press button On/Off for some
seconds to deactivate the appliance.
After some minutes from
the end of the
programme, the energy
saving function
automatically
deactivates the
appliance.
7. When the door locked light goes
off you can open the door.
8. Remove the laundry from the
appliance. Make sure that the drum
is empty.
9. Keep the door ajar, to prevent
mildew and odours.
10. Close the water tap.
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
11.1 NON-STOP programme
WARNING!
Do not put a plastic device/
ball for the detergent into
the drum.
1. Press button On/Off for some
seconds to activate the appliance .
2. Load the laundry one item at a time.
3. Put the detergent and the additives
in the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the symbols of the different
washing phases.
5. Set the available options.
WARNING!
Do not set a spin speed
lower than the automatic
speed of the set
programme.
11.2 Washing and Drying at
automatic levels
1. Press button Drying Level repeatedly
until the black line appears under
one of the dryness level symbol.
The iron dry level
The cupboard dry level
The extra dry level
The drying symbol comes on.
The anti-crease symbol comes on.
The display shows that the appliance is
ready to start.
The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load
size.
To have a good drying the
appliance does not let you
set a too low spin speed for
the items to be washed and
dried.
2.
Press button Start/Pause to start the
programme.
www.aeg.com
24