User manual

If the temperature and level of
the water in the drum are too
high, the door lock symbol stays
on and you cannot open the
door. To open the door do the
steps that follow:
1.
Deactivate the appliance.
2.
Wait for some minutes.
3.
Make sure that no water is in
the drum.
If you deactivate the appliance, it
is necessary to set the pro-
gramme again.
14. AT THE END OF PROGRAMME
• The appliance stops automatically.
• The acoustic signals operate.
•
In the display
comes on.
• The indicator of the Start/Pause but-
ton
6
goes off.
• The door lock symbol goes off.
•
Press button
1
to deactivate the ap-
pliance. After five minutes from the
end of the programme, the energy
saving function automatically deacti-
vates the appliance.
When you activate the appliance
again, the display show the end
of the last set programme. Turn
the programme knob to set a
new cycle.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is
completed, but there is water in the
drum:
– The drum turns regularly to prevent
the creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1.
If necessary, decrease the spin
speed.
2.
Press the Start/Pause button
6
.
The appliance drain the water and
spin.
3.
When the programme is completed
and the door lock symbol goes off,
you can open the door
4.
Deactivate the appliance.
The appliance drain and spin au-
tomatically after approximately
18 hours.
15. USING THE APPLIANCE - DRYING ONLY
WARNING!
Open the water tap. Put the drain
hose in the sink or connect to the
drain pipe.
• Load the laundry.
• Turn the programme dial to the pro-
gramme suitable for the items to dry.
The display shows a minimum time
value.
The drying symbol comes
on.
The anti-crease symbol
comes on.
The drying time symbol
comes on.
ENGLISH 21