Manual

ManualsBrandsAEG ManualsWashersL87695WD

• Make sure not to cause damage to the

mains plug and cable.

• Connect the mains plug to the mains

socket only at the end of the installa-

tion. Make sure that there is access to

the mains plug after the installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• Only for UK and Ireland. The appliance

has a 13 amp mains plug. If it is neces-

sary to change the fuse in the mains

plug, use a 13 amp ASTA (BS 1362)

fuse.

• Permanent connection. To connect

the appliance permanently, install a

double-pole isolating switch between

the appliance and the electricity supply.

It must have a minimum distance of 3

mm between the switch contacts and it

must be the correct type for the neces-

sary load. It must agree with the last

electrical legislation. The switch must

not break the yellow and green ground

cable.

Only a qualified electrician must install

this type of device.

DISPOSAL

WARNING!

Risk of injury or suffocation.

• Disconnect the appliance from the

mains supply.

• Cut off the mains cable and discard it.

• Remove the door catch to prevent chil-

dren and pets to get closed in the ap-

pliance.

TECHNICAL INFORMATION

Dimensions Width / Height / Depth 600 / 850 / 605 mm

Total depth 640 mm

Electrical connection: Voltage

Overall power

Fuse

Frequency

230-240 V

2200 W

13 A

50 Hz

Level of protection against ingress of solid particles

and moisture ensured by the protective cover, except

where the low voltage equipment has no protection

against moisture

IPX4

Water supply pressure Minimum 0,5 bar (0,05 MPa)

Maximum 8 bar (0,8 MPa)

Water supply

Cold water

Maximum wash load Cotton 8 kg

Maximum dry load Cotton 6 kg

Synthetics 3 kg

Spin speed Maximum 1400 rpm

Connect the water inlet hose to a water tap with a 3/4'' thread.