EN User Manual Washing Machine L 89495 FL2
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 5 4. CONTROL PANEL...........................................................................................................6 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth.
ENGLISH 2.3 Water connection • Make sure not to cause damage to the water hoses. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.4 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household only. • Obey the safety instructions on the detergent packaging.
www.aeg.com 3.2 How to activate the child safety device To close the door, turn the device anticlockwise until the groove is vertical. This device prevents children or pets to be closed in the drum. 3.3 Fixing plate kit (4055171146) Turn the device clockwise, until the groove is horizontal. You cannot close the door. Available from your authorized dealer. If you install the appliance on a plinth, secure the appliance in the fixing plates. Read carefully the instructions supplied with the accessory.
ENGLISH 4.2 Display A B C D L E K F G J H I The display shows: Temperature of the set programme A Cold water Spin speed of the set programme B No Spin symbol1) Rinse hold symbol 1) Only available for SPIN/DRAIN programme. The phase symbols When a programme is set, all the symbols of the phases related to the programme come on. When the programme starts, only the symbol of the phase in operation flashes. When the programme is completed, the symbol of the last phase is on.
www.aeg.com You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off. F If the programme is completed but the symbol stays on: • The «Rinse hold» function is on. • There is water in the drum. The delay start symbol comes on when you set the delay start function. G Programme time When the programme starts, the programme time decreases with steps of 1 minute.
ENGLISH 9 The extra rinse symbol comes on when this function is activated. K The value shows the total number of the rinses. The indicator bar is fully filled when you set the maximum number of rinses. the Stain symbol comes on when you activate the function. The Prewash symbol comes on when this function is activated. L The indicator bar is not fully filled when you set only one of the functions. The indicator bar is fully filled when you set the two functions. 5. PROGRAMMES 5.
www.aeg.com Programme Temperature range Wool/Silk 40° C - Cold Maximum load Maximum spin speed Programme description (Type of load and soil level) 2 kg 1200 rpm Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol.2) 3 kg 800 rpm Special programme for one synthetic blanket, duvet, bedspread and so on. 9 kg 1400 White cotton items. This programme removes micro-organisms thanks to the washing by 60°C and adds one rinse.
ENGLISH Programme Temperature range Maximum load Maximum spin speed 11 Programme description (Type of load and soil level) Steam programmes5) Steam can be used for dried, washed or worn once laundry. These programmes can reduce creases and odours and make your laundry more soft. Do not use any detergent. If necessary, remove stains by washing or using localized stain removal. Steam programmes do not perform any hygienic cycle.
www.aeg.com Programme options compatibility Programme Cottons Stain/ Spin ■ ■ Extra Silent Synthetics Easy Iron Extra Prewash 1) Rinse 2) Time Save 3) Delay Start ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 4) ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Delicates Wool/Silk Duvet ■ ■ ■ ■ ■ ■ ■ ■ Anti-Allergy Spin/Drain5) Rinse Cold Jeans ■ ■ ■ ■ ■ ■ ■ 20 min.
ENGLISH Programme Cottons Eco Stain/ Spin ■ Extra Prewash 1) Rinse 2) ■ ■ ■ Time 13 Save 3) Delay Start ■6) ■ 1) If you use liquid detergent, set a programme without Prewash. The Stain option is not available with a temperature lower then 40°C. 2) With a low spin speed the appliance performs delicate rinses and a short spin. 3) If you set a shorter duration, we recommend that you decrease the quantity of the load.
www.aeg.com Programmes Load (kg) Energy con- Water consumption sumption (kWh) (litre) ApproxiRemaining mate promoisture gramme du- (%)1) ration (minutes) Cottons 60 °C 9 1.55 87 220 52 Cottons 40 °C 9 0.97 87 205 52 Synthetics 40 °C 4 0.72 55 155 35 Delicates 40 °C 4 0.60 59 89 35 Wool/Silk 30 °C 2) 2 0.35 58 60 30 Standard cotton programmes Standard 60 °C cotton 9 0.64 57 226 52 Standard 60 °C cotton 4.5 0.34 41 185 52 Standard 40 °C cotton 4.5 0.
ENGLISH The related indicator comes on. The set of this option increases the programme duration. 7.5 Stain/Prewash Press this button to add the stain and/or a prewash phase to a programme. Press the button again and again to activate one or two options. The related symbol and the indicator bar comes on in the display. • Stains: Use this option for laundry with hard stains to remove. When you set this option, put the stain remover into compartment This function increases the programme duration. 15 .
www.aeg.com 9. BEFORE FIRST USE 1. Put a small quantity of detergent in the compartment for washing phase. 2. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. 10. DAILY USE WARNING! Refer to Safety chapters. 10.3 Filling the detergent and additives 10.1 Activating the appliance 1. Open the water tap. 2. Connect the mains plug to the mains socket. 3. Press button On/Off to activate the appliance.
ENGLISH 1 2 3. To use powder detergent, turn the flap up. A 17 With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit showed in the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 10.5 Setting a programme 4.
www.aeg.com 10.7 Starting a programme with the delay start 1. Press button Delay Start again and again until the display shows the number of minutes or hours of delay. The related indicator comes on. 2. Press button Start/Pause. The appliance starts the countdown of the delay start. When the countdown is completed, the programme starts automatically. Before you press button Start/Pause to start the appliance, you can cancel or change the set of the delay start. 10.
ENGLISH After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance. When you activate the appliance again, the display show the end of the last set programme. Turn the programme knob to set a new cycle. 2. Remove the laundry from the appliance. 3. Make sure that the drum is empty. 4. Keep the door ajar, to prevent mildew and odours 10.
www.aeg.com washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). • A very small load can cause balance problems with the spin phase. If this occurs, adjust manually the items in the tub and start the spin phase again. 11.2 Stubborn stains For some stains, water and detergent is not sufficient. We recommend that you remove these stains before you put the items in the appliance. Special stain removers are available.
ENGLISH Regularly examine the seal and remove all objects from the inner part. Always obey the instructions that you find on the packaging of the product. 12.5 Cleaning the drum 12.3 Maintenance wash Regularly examine the drum to prevent limescale and rust particles. Only use special products to remove rust particles from the drum. With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash.
www.aeg.com 12.7 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 1. 2. 2 1 1 2 1 3. 4. 1 5. 6.
ENGLISH 7. 8. 1 2 9. 2 1 12.8 Cleaning the inlet hose and the valve filter 1. 2.
www.aeg.com 3. 4. 45° 20° 12.9 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. When you drain the water with the emergency drain procedure, you must activate again the drain system: Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH • - No communication between electronic elements of the appliance. Switch off and switch on again. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre. 25 WARNING! Deactivate the appliance before you do the checks. 13.2 Possible failures Problem Possible solution The programme does not start. Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed.
www.aeg.com Problem Possible solution Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor.
ENGLISH Problem 27 Possible solution Decrease the laundry load. You cannot set an option. Make sure that you press only the wanted button(s). After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. 14.
www.aeg.
ENGLISH Washing noise on normal 60° C cotton programme dB/A 51 Spinning noise on normal 60° C cotton programme dB/A 75 29 1) Complies with EN60456. 16. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances * marked with the symbol with the household waste.
www.aeg.
ENGLISH 31
132903630-A-512014 www.aeg.