L 89499 FL EN User Manual
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 5 4. CONTROL PANEL...........................................................................................................6 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. 2.
ENGLISH 2.4 Use appliance. Contact the Authorised Service Centre to ensure which accessories can be used. • Do not touch the glass of the door while a programme operates. The glass can be hot. WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household only. • Obey the safety instructions on the detergent packaging. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance.
www.aeg.com 3.3 Installation on suspended flooring 3.4 Fixing plate kit (4055171146) Suspended wooden floors are particularly susceptible to vibration. Available from your authorized dealer. If you install the appliance on a plinth, secure the appliance in the fixing plates. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws, the wood panel must extend beyond the front feet.
ENGLISH 4.2 Display A B C D M E L F G H K I J The display shows: Temperature of the set programme A Cold water Spin speed of the set programme B No Spin symbol1) Rinse hold symbol 1) Only available for SPIN/DRAIN programme. The phase symbols When a programme is set, all the symbols of the phases related to the programme come on. When the programme starts, only the symbol of the phase in operation flashes. When the programme is completed, the symbol of the last phase is on.
www.aeg.com You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off. F If the programme is completed but the symbol stays on: • The «Rinse hold» function is on. • There is water in the drum. G The delay start symbol comes on when you set the delay start function. H The child safety lock symbol comes on when this device is activated. Programme time When the programme starts, the programme time decreases with steps of 1 minute.
ENGLISH 9 Graphic bars The empty indicator bar appears only if the related function is available for the set programme. The indicator bar fills accordingly to the set functions. If you make a wrong selection the message Err indicates that the selection is not possible. The time save symbol comes on when you set one of the programme duration. K Shortened time Extra Quick The extra rinse symbol comes on when this function is activated. L The value shows the total number of the rinses.
www.aeg.com Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) 9 kg White and coloured cotton. Normal soil and light soil. The programme eliminates all spinning phase to perform a silent cycle. The cycle stops with water in the tub. 3 kg 1200 rpm Synthetic items or mixed fabric items. Normal soil. 3 kg 800 rpm Synthetic items to be gentle washed. Normal and light soil.
ENGLISH Programme Temperature range Super Eco 30° 3) 11 Maximum load Maximum spin speed Programme description (Type of load and soil level) 3 kg 1200 rpm Cottons, synthetics and mixed fabrics. Normal soil. 9 kg 1400 rpm White cotton and colour-fast cotton. Normal soil. The energy consumption decreases and the time of the washing programme is extended. 30°C - Cold Cottons Eco4) 60°C - 40° C Steam programmes5) Steam can be used for dried, washed or worn once laundry.
www.aeg.com Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) 1.5 kg Steam programme for synthetic items. This cycle helps to dewrinkle the laundry. Anticrease 40° C 1) To reduce the creases of the laundry, this cycle regulates the water temperature and performs a soft wash and spin phase. The appliance adds some rinses. 2) During this cycle the drum rotates slowly to ensure a gentle washing.
ENGLISH Programme Stain/ Extra Prewash 1) Rinse 2) Spin Rinse ■ ■ ■ Outdoor ■ ■ ■ 20 min.-3Kg ■ Super Eco ■ ■ ■ ■ Cottons Eco Time Save 3) 13 Delay Start ■ ■ ■ ■ ■ ■ ■ ■ ■6) ■ 1) If you use liquid detergent, set a programme without Prewash. The Stain option is not available with a temperature lower then 40°C. 2) With a low spin speed the appliance performs delicate rinses and a short spin. 3) If you set a shorter duration, we recommend that you decrease the quantity of the load.
www.aeg.com Programme Temperature range Delicates 40° C - Cold Maximum load Maximum spin speed Programme description (Type of load and soil level) 3 kg 1200 rpm Delicate fabrics as acrylics, viscose, polyester items. Normal soil. 2 kg 1200 rpm Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol. 3 kg 800 rpm Special programme for one synthetic blanket, duvet, bedspread and so on. 9 kg 1400 White cotton items.
ENGLISH Programme Temperature range Maximum load Maximum spin speed 15 Programme description (Type of load and soil level) Steam programmes Steam can be used for dried, washed or worn once laundry. These programmes can reduce creases and odours and make your laundry more soft. Do not use any detergent. If necessary, remove stains by washing or using localized stain removal. Steam programmes do not perform any hygienic cycle.
www.aeg.com Programme Stain/ Prewash Spin Extra Rinse Rinse ■ ■ ■ Outdoor ■ ■ ■ 20 min.-3Kg ■ Super Eco ■ ■ ■ ■ Cottons Eco Time Save Delay Start ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 6. CONSUMPTION VALUES The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature. At programme start the display shows the duration programme for the maximum load capacity.
ENGLISH Programmes Load (kg) Energy con- Water consumption sumption (kWh) (litre) Standard 40 °C cotton 4.5 0.35 40 ApproxiRemaining mate promoisture gramme du- (%) 1) ration (minutes) 199 52 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0,05 0,05 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 7. OPTIONS 7.1 Start/Pause 7.
www.aeg.com The display shows only the spin speeds available with the set programme. • Deactivate the spin phase. • Activate the Rinse Hold function. Set this function to prevent fabric creases. The appliance does not drain the water when the programme is completed. 7.7 Temperature Press this button to change the default temperature. When the display shows and , the appliance does not heat the water. 8. SETTINGS 8.
ENGLISH 10.1 Using weight sensors For a correct operation of the weight sensor, activate the appliance and set the programme BEFORE you put the laundry in the drum. 10.2 Before activating the appliance 1. Open the water tap. 2. Connect the mains plug to the mains socket. 10.3 Activating the appliance and setting a programme 1. Press button AutoOff to activate the appliance. 2. Turn the programme knob to the necessary programme. The programme indicator comes on.
www.aeg.com 10.5 Filling the detergent and additives 3. To use powder detergent, turn the flap up. A 4. To use liquid detergent, turn the flap down. Compartment for prewash phase an soak programme. Compartment for washing phase. B Compartment for liquid additives (fabric conditioner, starch). Maximum level for quantity of liquid additives. Compartment for stain remover. Flap for powder or liquid detergent. Always obey the instructions that you find on the packaging of the detergent products.
ENGLISH 10.7 Starting the programme without the delay start Press button Start/Pause to start the programme. The related indicator stops flashing and stays on. On the display all indicator related to the load and to the quantity of detergent go off. The indicator of the phase in operation flashes. 10.8 Starting a programme with the delay start 1. Press button Delay Start again and again until the display shows the number of minutes or hours of delay. The related indicator comes on. 2.
www.aeg.com In the display the related door lock indicator goes off. 2. Open the appliance door. 3. Close the door and press button Start/Pause. The programme or the delay start continues. 10.14 End of cycle When the programme has finished, the appliance stops automatically. The acoustic signal operates (if it is active). In the display comes on and the door locked indicator goes off. The indicator of Start/Pause button goes off. 1. Press button AutoOff to deactivate the appliance.
ENGLISH • Turn inside out multilayered fabrics, wool and items with painted illustrations. • Remove hard stains. • Wash with a special detergent heavy soil stains. • Be careful with the curtains. Remove the hooks or put the curtains in a washing bag or pillowcase. • Do not wash in the appliance laundry without hems or with cuts. Use a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). • A very small load can cause balance problems with the spin phase.
www.aeg.com 12.4 Door seal 12.2 Descaling If the water hardness in your area is high or moderate, we recommend that you use a water softener for washing machines. Regularly examine the drum to prevent limescale and rust particles. To remove rust particles use only special products for washing machine. Do this separately from the laundry wash. Regularly examine the seal and remove all objects from the inner part. Always obey the instructions that you find on the packaging of the product. 12.
ENGLISH 3. 4. 12.7 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 1. 2. 2 1 1 2 1 3. 4.
www.aeg.com 5. 6. 1 2 7. 8. 1 2 9.
ENGLISH 27 12.8 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 45° 20° 12.9 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1.
www.aeg.com 13. TROUBLESHOOTING • - The appliance does not drain the water. • The start of the appliance does not occur or it stops during operation. - The appliance door is open or not closed correctly. Please check the door! • First try to find a solution to the problem (refer to the table). If not, contact the Authorised Service Centre. - The mains supply is unstable. Wait until the mains supply is stable. • - The anti-flood device is on. Disconnect the appliance and close the water tap.
ENGLISH Problem Possible solution The appliance does not drain the water. Make sure that the sink spigot is not clogged. 29 Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct. Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub.
www.aeg.com Problem Possible solution The cycle is shorter than the time displayed. The appliance calculates a new time according to the laundry load. See the ‘Consumption Values’ chapter. The cycle is longer than the time displayed. An unbalanced laundry load increases the duration time. This is a normal behaviour of the appliance. The washing results are not satisfactory. Increase the detergent quantity or use a different detergent.
ENGLISH 3. Open the filter flap. 4. Keep the emergency unlock trigger pulled downward and, at the same time, open the appliance door. 31 5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 14.
132908390-A-082014 www.aeg.
