User manual

10.12 Opening the door
WARNING!
If the temperature and level
of the water in the drum are
too high and the drum still
rotates you cannot open the
door.
While a programme or the delay start
operates, the appliance door is locked.
To open the appliance door:
1. Touch button Start/Pause.
The door lock symbol in the display goes
off.
2. Open the appliance door.
3. Close the appliance door and touch
button Start/Pause.
The programme or the delay start
continues
10.13 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Touch the Start/Pause button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator goes off,
you can open the door.
4. Press On/Off some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
10.14 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Start/Pause
button.
Press the button On/Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button On/Off to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
10.15 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and a
message tells you that the programme is
completed.
The indicator of Start/Pause button goes
off.
1. Press the button On/Off to
deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and air filter ajar, to
prevent mildew and odours.
5. Close the water tap.
ENGLISH
23