User guide

Installation on suspended
flooring
Suspended wooden floors are particular-
ly susceptible to vibration. To help pre-
vent vibration we recommend you place
a waterproof wood panel, at least 15 mm
thick under the appliance, secured to at
least 2 floor beams with screws, the
wood panel must extend beyond the
front feet.
If possible install the appliance in one of
the corners of the room, where the floor
is more stable
15.4 The inlet hose
20
O
20
O
20
O
45
O
45
O
45
O
• Connect the hose to the appliance.
Turn the inlet hose only left or right.
Loose the ring nut to set it in the cor-
rect position.
• Connect the water inlet hose to the
cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no leaks
from the couplings.
Do not use an extension hose if
the inlet hose is too short. Con-
tact the service centre for the re-
placement of the inlet hose.
Water pressure
The appliance works correctly if the wa-
ter pressure is not less than 0.05 MPa
(0.5 bar).
If you can not connect the water inlet
hose to the cold water tap of the primary
hydraulic system, connect it to your do-
mestic cold water storage system.
Make sure not to have more than a dis-
tance of 5.02 m (16.5 ft) between the ap-
pliance inlet hose and the bottom of the
water storage tank.
38
www.aeg.com