User manual

• You do not use the appliance for 5
minutes before you press Start/Pauze
- Départ/Pause button.
Press the button Aan/Uit - Marche/
Arrêt to activate the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button Aan/Uit - Marche/
Arrêt to activate the appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
10.15 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and a
message tells you that the programme is
completed.
The indicator of Start/Pauze - Départ/
Pause button goes off.
1. Press the button Aan/Uit - Marche/
Arrêt to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and air filter ajar, to
prevent mildew and odours.
11. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
11.1 Preparation to drying
1. Press button Aan/Uit - Marche/Arrêt
for some seconds to activate the
appliance
2. Load the laundry one item at a time.
3. Turn the programme dial to the
drying programme applicable for the
items to dry.
The text bar in the display tells which
programme you have chosen.
When drying a big amount
of laundry, to have good
drying performances, make
sure that the laundry itself is
not rolled up and that is
uniformly distributed in the
drum.
At the beginning of the
drying cycle (3 – 5 min.)
there could be a slightly
higher sound level. This is
the compressor start and it is
quite normal for compressor
powered appliances such
refrigerators, freezers and so
on.
11.2 Automatic drying
1. Touch button Automatisch -
Automatique repeatedly to set the
required dryness level. The indicators
on the control panel illuminate
accordingly:
a. IRON DRY level - 1 indicator on:
for cotton items
b. CUPBOARD DRY level - 2
indicators on: for cotton and
synthetic items
c. EXTRA DRY level - 3 indicators
on : indicator for cotton items
www.aeg.com
24