User manual

Problem Possible solution

Make sure that there is not a damaged fuse in the fuse

box.

Make sure that the you have touched Start/Pauze - Dé-

part/Pause.

If the delay start is set, cancel the setting or wait for the

end of countdown.

Deactivate the Child Lock function if it is on.

The appliance does not drain

the water.

Make sure that you have not set a programme without

drain phase.

Make sure that you have not set an option which ends

with water in the tub.

The appliance fills with water

and drains immediately.

Make sure that the drain hose is in the correct position.

The hose may be too low.

The spin phase does not op-

erate or the washing cycle

lasts longer than usually.

Make sure that the spin phase is not off.

Make sure that the drain filter is not clogged. Clean the

filter, if necessary. Refer to 'Care and cleaning'.

Make sure that the this is not a balance problem. Adjust

manually the items in the drum and start the spin phase

again.

There is water on the floor. Make sure that the couplings of the water hoses are tight

and there is not water leakages.

Make sure that the drain hose have no damages.

Make sure you use the correct detergent and the correct

quantity of it.

Make sure you use that the room temperature is in the

correct range.

Make sure you use that there is enough air circulation un-

der the appliance.

You cannot open the appli-

ance door.

Make sure that the washing programme is finished.

Set the drain or the spin programme if there is water in

the drum.

Make sure that the appliance receives electrical power.