User manual

To a wall-pipe
• Directly to a built-in drain pipe in the room
wall and tighten it with a clip.
You can extend the drain hose to maximum 400 cm. Contact the service
centre for the other drain hose and the extension.
17. TECHNICAL DATA
Dimension Width/ Height/ Depth/ Total depth 600 mm/ 870 mm/
605 mm/ 640 mm
Electrical connection Voltage
Overall power
Fuse
Frequency
230-240 V
2200 W
13 A
50 Hz
Level of protection against ingress of solid particles and moisture
ensured by the protective cover, except where the low voltage
equipment has no protection against moisture
IPX4
Water supply
1)
Cold water
Water supply pressure
2)
Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Ambient temperature Minimum 5 °C
Maximum 35 °C
Maximum wash load Cotton 9 kg
Synthetics 4 kg
Wool 1.5 kg
Maximum dry load Cotton 6 kg
Synthetics 4 kg
Wool 1 kg
Spin Speed Maximum 1600 rpm
This product contains HFC - R134a/GWP1430 0.12 kg fluorinated gas hermetically sealed.
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
2)
The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your
domestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the bottom of the water storage tank.
www.aeg.com44