User manual

Installation and Connection Instructions
49
Fitting and Earthing the Sheet Metal Cover
0 1. Insert the cover from behind, fitting the
slots in the worktop brackets (5), and
slide forwards.
Important! The four metal tags must
slide underneath the mounting plate at
the front (6).
2. Screw the cover in place using the ser-
rated lock washers (7) and screws (8)
included in the built-in installation kit.
1
Warning! It is essential that the screws
(8) are earthed and secured through the
serrated lock washers (7).
Water Vapour Protection for Work Surfaces
The built-in installation kit includes a piece of protective foil for pro-
tecting the work surface around the switch panel and the detergent
drawer from water vapour.
When applying, ensure that the edge of the foil is exactly aligned with
the front edge of the work surface.
Sliding Rails
Sliding rails on the left and right provide assistance when sliding the
appliance into the niche and prevent the floor being damaged.
Sliding rails are included in the built-in installation kit.