User manual

Installation and Connection Instructions
53
Incorporating in Kitchens with 90cm High
Work Surfaces
A special base is used to adapt the height of the appliance, this is to be
provided by the kitchen manufacturer.
Dimensions: Width x Height x Depth = 600 x 50 x 490mm.
Material: work surface 30, 33 or 40mm thick, normally coated, with
reinforcing (if possible made of solid wood) to create a platform
40-50mm high. The reinforcement should be in the form of a frame to
make it easier to compensate for unevenness in the floor. Two holes
(diameter 8-10mm) are required on the left and right for fixing the
base to the floor using plugs and screws. For safety reasons it is recom-
mended to also fit a 5-10mm high edge to the front of the base.