User manual

18
Adjusting the washing program
Refer to the programs table in the next chapter to choose the appropriate
program, the right temperature and any other programs for each type of
washing.
1. Adjust the washing program: put the programmer to the required
program.
2. Adjust the temperature: put the thermostat to the required temperature.
3. Choose the additional program(s) if any:
Press on the same button again to change or cancel the selection.
Adding detergents
Open the lid.
Lift the lid using the handle. To open the drum, press on the drum door
button and open it, pushing slowly downwards. Insert the washing, close
the drum and the lid.
Refer to the “programs table” to determine the maximum quantity of
washing.
Add detergents.
Refer to the section entitled “Products” for information about detergents.
Compartment 1
Stain removal salt for programs without pre-wash;
powder detergent for programs with pre-wash or
soak.
Compartment 2
Powder detergent for the main wash (if you are
using a softener, put the softener in compartment 2 with the detergent).
Compartment 3
Liquid additives (softener, crease remover, starch).
Warning! Do not fill compartment 3 above the MAX mark. Dilute thick
liquid products if necessary to reach the MAX. mark, and dissolve starch.
Close the lid.
Make sure that the drum door is properly closed before you close the lid.
Warning ! Take care that your washing does not get trapped when you close
the lid! You could damage the washing and the washing machine.
.
User's instructions
1
2
3