User manual

23
Troubleshooting
Problem solving
If a problem occurs, try to solve it yourself using the information in the
following table. The technician’s work will not be free even during the
guarantee period, if you call the After Sales Service to solve a problem
which you could have solved by reading this table, or if you make a false
maneuver.
Problem
The washing machine
will not start.
The machine will not
fill up with water.
The machine vibrates
during the program
or it is very noisy.
Possible cause
The power supply plug is not
plugged in.
The installation main fuse is
burned out.
The cover is not properly
closed.
The ON/OFF button "
" was
not pressed for long enough.
The water supply tap is closed.
The water supply filter is
blocked.
The leveling screws are not
correctly adjusted.
You have not put in enough
washing (for example there is
only one bath towel).
The machine was not com-
pletely emptied before it
started to spin, because:
- the drain pipe is folded.
- the detergent pump is
blocked.
Remedy
Put the plug in.
Replace the fuse.
Close the lid - you should
hear a locking noise.
Press the ON/OFF button "
"
until the program starts.
Open the water supply tap.
Unscrew the water supply pipe,
take out the filter and clean it
under running water.
Adjust the leveling screws in
accordance with the instal-
lation and connection instruc-
tions.
This does not upset operation
of the washing machine.
Check the position of the drain
pipe and if necessary elimi-
nate the fold, or clean the
detergent pump and remove
any foreign bodies in it.
User's instructions