User manual

24
User's instructions
Problem
Excessive foam for-
mation during the
main wash.
There is water around
the washing machine
The washing is not
sufficiently spun or
there is still water in
the drum.
Traces of products
remain in the deter-
gent dispenser.
Possible cause
You probably put in too much
detergent.
The water supply pipe is not
screwed on tightly.
The water supply pipe leaks
The filter plug is not properly
closed.
Washing is stuck in the cover.
The drain pipe is folded.
The height of the end of the
drain pipe is greater than the
maximum height (80 cm
above the bottom of the
machine).
The detergent pump is
blocked.
The siphon connector is
blocked.
The water supply tap is not
fully open.
The water supply filter is
blocked.
The filter is blocked at the
location of the supply pipe
fastener.
Remedy
Dose the detergent exactly
according to the manu-
facturer’s instructions.
Screw the water supply pipe
on tightly.
Check the water supply pipe
and replace it if necessary.
Close the plug correctly.
Stop the program, release
washing from the cover, and
start a new program.
Straighten out the fold.
Call the After Sales Service
which will provide an instal-
lation kit for discharge
heights greater than 80 cm.
Disconnect the washing ma-
chine, pull out the power
supply plug and clean the
detergent pump.
Clean the siphon.
Fully open the water supply
pipe.
Clean the filter.
Clean the filter.