User manual

35
Water connections
The washing machine is provided with safety equipment that prevents dirty
water from flowing backwards into the drinking water supply pipes, in
accordance with national water company specifications. Therefore there is
no need to use any other additional protection in the installation.
Warning ! Washing machines designed to be connected to a cold water pipe
must not be supplied with hot water!
Allowable water pressure
The water pressure shall be not less than 0,5 bar (= 5 N/CM
2
= 0.05 MPa) and not
more than 8 bars (= 80 N/CM
2
= 0,8 MPa):
Install a pressure reducer if the pressure exceeds 8 bars.
If the pressure is below 0,5 bar, unscrew the supply pipe on the magnetic
inlet valve on the washing machine, and remove the flow regulator (to
do this, you will need to remove the filter using pliers, and then rubber
washer under it). Then put the filter back into position.
Water supply
A 1.5 m long supply pipe is provided with the
washing machine.
If you need to use a longer supply pipe, only use
a complete set of pipes fitted with installed
screw-on end pieces, supplied by our After Sales
Service.
Warning ! Never use odd pieces of pipe as
extensions!
Sealing rings are supplied either inside the plastic nuts, or with the
accessories supplied with the washing machine. Do not use other sealing
rings.
sealing ring
Installation and connection instructions