User manual

Programmes end by:

a spin for all the programmes,

a drain for all the programmes if you have selected the no spin

position " " on the spinning speed variator,

a stop with the tub full of water (for all programmes) if you selected

the rinse hold position " " on the spinning speed variator. You can

then complete these programmes by a spin by choosing a spinning

speed or by a drain by placing the timer on the Drain programme " ";

but do not forget to release the On/Off "

" button before your

selection.

Release the On/Off button "

" at the end of the cycle to switch your washing

machine off. The light extinguishes. Release any other buttons. Full the main

plug out and close the water supply tap. Make sure that the drum is empty;

any fabric which would be remained inside could be damaged during the

next wash (shrinkage) or it could lose its color onto other items of washing.

WARNING:

YOU CANNOT OPEN THE COVER UNTIL ABOUT 2 MINUTES AFTER THE

MACHINE HAS STOPPED.

If your washing is not spun at the end of the cycle, check that the load is

properly distributed in the drum before restarting a spin cycle (see “Anti-

unbalanced weight” section).

Note:

We recommend you to leave the cover and the drum open after use in order

to air the tub.

User's instructions