User manual

28
Troubleshooting
Your washing machine was checked many times during the manufacturing.
However, it is always possible that something happens. Please refer to the
following table before calling the After Sales Service.
User instructions
There is no water in the washing machine.
The washing machine will not fill.
The washing is not properly clean.
The wash cycle is too long.
The machine stops during the wash cycle.
The machine fills up and then drains straight
away.
Check that:
- the water supply tap is fully open,
- the filter is not blocked.
Check that:
- the water supply tap is open and the pressure
is sufficiently high,
- the washing machine cover is properly closed,
- there is no power supply failure.
Check that:
- the detergent is suitable for machine washing,
- you have not tried to do too much washing in
one load,
- the washing programme is appropriated.
Check that:
- the water pressure is high enough,
- the water inlet filter is not blocked,
- there is no power supply failure.
Check that:
- the water pressure is high enough,
- the water inlet filter is not blocked,
- fuses are in good condition and have not
tripped,
- the rinse hold position "
" is selected.
Check that:
- the drain pipe is not attached too low.
Symptoms
Solutions