User manual

7
User's instructions
All packing devices must be removed from the washing machine before
using it. Severe damage may occur to the washing machine or adjacent
furniture if you forget to remove any of the transport protection
packing. Always unplug the washing machine before removing packing.
All repairs to the washing machine must be made by qualified personnel.
Safety devices
Cover: your washing machine is equipped with a safety device preventing
the washing machine cover from closing when the drum doors are open.
It is impossible to start it until the doors are closed. An electromechanical
safety device prevents you from opening the cover while the washing
machine is operating, and for about 2 minutes after the end of the
programme.
Washing motor: a temperature safety device protects the motor against
risks of mechanical overload, or overvoltage or undervoltage.
Heating: heating will not start until the necessary water quantity for
washing has been added into the tank. This safety device is mainly
effective when the water supply is cut off or if you forget to open the
water supply tap.
The anti-foam system: water consumption is very low, due to the
electronic spin cycle with an intermediate spin after the main wash and
three rinse cycles for white and colour programmes. The spin cycle
remains under the control of the foam detection system after the wash
cycle has finished. If necessary, the spin cycle will stop until all foam is
removed.
The unbalanced weight protection system: this safety system keeps the
washing machine stable during intermediate spins or the final spin and
therefore detects any bad distribution of your washing (small load or
tangled washing). It can then remedy this situation.
The drum positionning system: this electronic system ensures that the
doors are in the high position when the wash programme is finished in
order to allow for easier loading and unloading of the laundry.