User manual

61
What to do if ...
... The washing machine does not work at all ?
Is the machine connected to the power supply?
Was a programme selected?
Was the ON button pushed?
Are all the lids closed?
... No water runs in ?
Is the water tap open?
Is the filter in the water inlet blocked ?
... The spin cycle begins after a delay ?
The electronic balance control system of the ma
chine has operated due to unfavourable distribution of
the wash. The wash is separated by reversing
movements of the drum, redistributed and the spin
cycle begins again. This can occur several times until
the unbalance is removed and spinning can finally
begin.
... The washing machine vibrates or does not stand
still?
With very small loads (e.g. only a bathing costume) the
machine may vibrate. This has no effect on operation.
Are the adjustable feet properly adjusted? Follow the
instructions for installation
Is the discharge hose bent ?
Are the transport securings completely removed ?
Follow the instructions for installation
... The spin speed varies and is irregular ?
The electronic foam control has temporarily reduced
spin speed due to strong suds build-up, in order to
remove the foam. Spinning will start again afterwards.
Check detergent quantities at the next wash.
... The sound of the machine is unusual ?
The machine has a modern transmission system, which
has a different sound compared to older transmissions,
and resembles a whistling sound. The new transmis
sion system enables smooth spin starts and a regular
high speed spin. Level operation is improved and water
consumption reduced.
... The detergent in the main wash foams strongly ?
Was too much, or the wrong detergent used ? Check
the quantities added more precisely.
Problems you
can solve your-
self