User manual

21
Washing machine vi-
brates when operating
or is noisy.
Transit packaging has not
been removed.
Remove transit packaging.
Screw feet not correctly ad-
justed.
Adjust feet according to the
Installation and Connection
instructions.
There is very little washing
in the drum (e.g., just one
bath robe).
This does not affect how the
machine operates.
Water is leaking out un-
derneath the washing
machine.
Screw connection on the in-
let hose is leaking.
Tighten inlet hose.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
Washing water is foam-
ing excessively.
Probably too much deter-
gent has been used.
Dose detergent exactly as in-
structed by manufacturer.
END display flashes 2x.
(Problems with water
outflow.)
Kink in drain hose. Remove kink.
Maximum pumping height
of 1m exceeded.
Please contact Customer
Care Department.
Drain pump is blocked.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove
foreign bodies from pump
housing.
With connection to sink
outlet: sink outlet is
blocked.
Clean sink outlet.
Fabric softener not
rinsed in, w compart-
ment for additives is
filled with water.
Conditioner insert in the
compartment for additives
is not correctly attached or
is blocked.
Clean detergent dispenser
drawer, insert conditioner in-
sert firmly.
Problem Possible cause Remedy