User manual

Operating Instructions
27
Interrupting the programme
0 To interrupt the wash programme before it is complete, turn the pro-
gramme selector to OFF.
3
The wash programme can be interrupted at any time with the START/
PAUSE button and can be continued by pressing the button again.
Wash Cycle Complete/Removing Washing
Once the wash programme has come to an end, END is illuminated on
the programme progress display.
3
The washing machine switches to standby mode if no button is pressed
or the programme selector is not turned within approx. 3 minutes after
the end of the programme. Only END is illuminated from behind. All
other displays on the control panel are switched off in order to save en-
ergy. Pressing any button cancels the standby mode.
• If the EASY IRON programme has been selected there will be an anti-
crease stage of approx. 30 minutes after the programme has ended.
The multi-display indicates that 1 minute still remains and the END
indicator is illuminated. You can open the door at any time during
the anti-creasing stage and remove the washing.
• If spin speed 0 (rinse hold) has been selected START/PAUSE will flash.
0 1. After a rinse hold, the water must first be pumped out:
– Press either the START/PAUSE button (the water will be pumped out
and the washing spun in accordance with the programme which has
just been completed; the spin speed can also be changed during spin-
ning using the SPIN SPEED button, or
– Turn the programme selector to DRAIN and press the START/PAUSE
button (the water is pumped out without spinning), or
– Turn the programme selector to SPIN or SHORT SPIN and press the
START/PAUSE button (the water is pumped out and the washing is
spun fast or slow).
At the end of this stage of the programme END is illuminated from be-
hind.
2. Open the door.
As soon as DOOR/LIGHT is illuminated in green the door can be opened
(not when programme protection has been activated, please see “Pro-
gramme Protection”).
3. Remove the washing.
4. Turn the programme selector to OFF.