User manual

Operating Instructions
26
Multi-display
The remaining wash time (in minutes) is
displayed in the multi-display until the pro-
gramme has finished.
3
The remaining wash time may increase or remain stationary during the
wash cycle because the wash programme adjusts itself to the various
conditions as the wash sequence progresses (e.g. type and quantity of
washing, identification of imbalance during spin cycle, special rinse
etc.).
É (MOISTURE%)/ Ç (LOADING%) display
The following appear alternately in the dis-
play:
• The expected residual moisture in the wash-
ing at the end of the programme. This values
depends on the spin speed set.
• The load in the drum (in graduations of 10 percent).
This value is only displayed for the t } (COTTONS/LINEN, EASY-
CARES) programme.
The washing machine cannot recognise the load until about ten min-
utes after a programme has started. As soon as a value for the load is
available the display alternates between residual moisture and load-
ing.
If the drum is too heavily loaded this is displayed with a value
of 120 (percent).
3
Due to the differences in fabric type and load, the remaining moisture
value is lower for < (EASY IRON) and à (DELICATES) than for
t } (COTTONS/LINEN, EASY-CARES), cotton.
Changing the Spin Speed
The spin speed can still be changed during the wash programme, or
rinse hold (display 0) can be set.
Other settings cannot be changed.
Interrupting the programme
0 To interrupt the wash programme before it is complete, turn the pro-
gramme selector to I (OFF).
3
The wash programme can be interrupted at any time with the O/s
(START/PAUSE) button and can be continued by pressing the button
again.