User manual

Operating Instructions

Wash Cycle Complete/Removing Washing

Once the wash programme has come to an end, L (END) is illuminated

on the programme progress display.

The washing machine switches to standby mode if no button is pressed

or the programme selector is not turned within approx. 3 minutes after

the end of the programme. Only L (END) is illuminated from behind.

All other displays on the control panel are switched off in order to save

energy. Pressing any button cancels the standby mode.

• If the < (EASY IRON) programme has been selected there will be an

anti-crease stage of approx. 30 minutes after the programme has

ended. The multi-display indicates that 1 minute still remains and

the L (END) indicator is illuminated. You can open the door at any

time during the anti-creasing stage and remove the washing.

• If spin speed 0 (rinse hold) has been selected O/s (START /PAUSE)

will flash.

0 1. After a rinse hold, the water must first be pumped out:

– Press either the O/s (START/PAUSE) button (the water will be

pumped out and the washing spun in accordance with the pro-

gramme which has just been completed; the spin speed can also be

changed during spinning using the K (SPIN SPEED) button, or

– Turn the programme selector to v (DRAIN) and press the

O/s (START/PAUSE) button (the water is pumped out without

spinning), or

– Turn the programme selector to K (SPIN) or L (SHORT SPIN) and

press the O/s (START/PAUSE) button (the water is pumped out and

the washing is spun fast or slow).

At the end of this stage of the programme L (END) is illuminated from

behind.

2. Open the door.

As soon as

/W (DOOR/LIGHT) is illuminated in green the door can be

opened (not when programme protection has been activated, please see

“Programme Protection”).

3. Remove the washing.

4. Turn the programme selector to I (OFF).

5. After washing, pull out the detergent dispenser drawer slightly so that

it can dry out. Leave the door slightly ajar so that air can circulate in

the drum.