User manual

Operating Instructions
35
The drain pump in the
washing machine is
running continuously -
even with the appli-
ance switched off.
The Aqua Control water pro-
tection system has cut in.
Turn off the tap, then unplug
the appliance from the mains
and contact customer serv-
ice.
Softener was not
washed into the ma-
chine; compartment æ
for conditioner is filled
with water.
The conditioner insert has
not been correctly positioned
inside the conditioner com-
partment or is blocked.
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Washing is heavily
creased.
Probably too much washing
was put in the drum.
Follow instructions for the
maximum load quantity (see
programme tables). For easy-
care fabrics select the <
(EASY IRON) programme.
The washing has not
been spun as dry as
usual.
The washing was not able to
be distributed evenly in the
drum prior to spinning.
Always load the drum as ful
as possible with a combina-
tion of large and small items.
Washing has not been
spun properly. Water is
left in the drum.
Fault code
(2 ap-
pears
.
Drain hose is kinked. Remove the kink.
Maximum pump head (outlet
head 1m from floor surface
on which appliance is stand-
ing) exceeded.
Contact your local Customer
Service Centre. For pumping
heights over 1m a conver-
sion kit is available as a spe-
cial accessory.
Drain pump is blocked.
Switch off the appliance and
pull out the mains plug.
Clean the drain pump.
If a siphon is connected: si-
phon blocked.
Clean the siphon.
The door cannot be
opened when the ap-
pliance is switched on.
The door is locked for safety
reasons. The
K
/W (DOOR)
indicator is not illuminated
from behind.
Wait until
K
/W (DOOR) is il-
luminated in green.
The programme protection
has been set.
Cancel programme protec-
tion (see “Programme Pro-
tection”).
The washing machine is in
standby mode.
Press
K
/W (DOOR) button
again.
Problem Possible Cause Remedy