User manual

Instructions for use

Interrupting the programme

0 To interrupt the wash programme before it is complete, turn the pro-

gramme selector to OFF (UIT).

The wash programme can be interrupted at any time with the START/

PAUSE (START/PAUZE) button and can be continued by pressing the

button again.

Wash Cycle Complete/Removing Washing

Once the wash programme has come to an end, END (EINDE) is illumi-

nated on the programme progress display.

The washing machine switches to standby mode if no button is pressed

or the programme selector is not turned within approx. 3 minutes after

the end of the programme. Only END (EINDE) is illuminated from be-

hind. All other displays on the control panel are switched off in order to

save energy. Pressing any button cancels the standby mode.

• If the EASY IRON (STRIJKVRIJ) programme has been selected there

will be an anti-crease stage of approx. 30 minutes after the pro-

gramme has ended. The multi-display indicates that 1 minute still re-

mains and the END (EINDE) indicator is illuminated. You can open the

door at any time during the anti-creasing stage and remove the

washing.

• If spin speed 0 (rinse hold) has been selected START/PAUSE (START/

PAUZE) will flash.

0 1. After a rinse hold, the water must first be pumped out:

– Press either the START/PAUSE (START/PAUZE) button (the water will

be pumped out and the washing spun in accordance with the pro-

gramme which has just been completed; the spin speed can also be

changed during spinning using the SPIN SPEED (CENTRIFUGETOEREN-

TAL) button, or

– Turn the programme selector to DRAIN (POMPEN) and press the

START/PAUSE (START/PAUZE) button (the water is pumped out with-

out spinning), or

– Turn the programme selector to SPIN (CENTRIFUGEREN) or SHORT

SPIN (KORT CENTRIFUGEREN) and press the START/PAUSE (START/

PAUZE) button (the water is pumped out and the washing is spun fast

or slow).

At the end of this stage of the programme END (EINDE) is illuminated

from behind.