User manual

Operating Instructions
27
Changing the Spin Speed
The spin speed can still be changed during the wash programme, or
rinse hold (display 0) can be set.
Other settings cannot be changed.
Interrupting the programme
To interrupt the wash programme before it is complete, turn the pro-
gramme selector to I (OFF).
3
The wash programme can be interrupted at any time with the O/s
(START/PAUSE) button and can be continued by pressing the button
again.
Wash Cycle Complete/Removing Washing
Once the wash programme has come to an end, L (END) is illuminated
on the programme progress display.
3
The washing machine switches to standby mode if no button is pressed
or the programme selector is not turned within approx. 3 minutes after
the end of the programme. Only L (END) is illuminated from behind.
All other displays on the control panel are switched off in order to save
energy. Pressing any button cancels the standby mode.
• If the < (EASY IRON) programme has been selected there will be an
anti-crease stage of approx. 30 minutes after the programme has
ended. The multi-display indicates that 1 minute still remains and
the L (END) indicator is illuminated. You can open the door at any
time during the anti-creasing stage and remove the washing.
• If spin speed 0 (rinse hold) has been selected O/s (START /PAUSE)
will flash.
1. After a rinse hold, the water must first be pumped out:
– Press either the O/s (START/PAUSE) button (the water will be
pumped out and the washing spun in accordance with the pro-
gramme which has just been completed; the spin speed can also be
changed during spinning using the K (SPIN SPEED) button, or
– Turn the programme selector to v (DRAIN) and press the
O/s (START/PAUSE) button (the water is pumped out without
spinning), or
– Turn the programme selector to K (SPIN) or L (SHORT SPIN) and
press the O/s (START/PAUSE) button (the water is pumped out and
the washing is spun fast or slow).
At the end of this stage of the programme L (END) is illuminated from
behind.